Успей купить — скидки до 50%!
В корзине {{totalProductsCount}} товар(ов)
Ваша корзина пуста
Hello!
To connect the boundary wires to the rear of the ROBOTIC LAWNMOWER KC8B102-A charging station without connectors, follow these steps:
Strip the wire ends:
Carefully strip about 1–1.5 cm (½ inch) of insulation from the ends of the boundary wires.
Locate the terminals on the rear of the charging station:
You should see clearly marked connection points (often labeled as L, R, or with icons) for the left and right boundary wires.
Insert the bare wires directly:
Insert the stripped ends of the boundary wires directly into the spring-loaded terminals or screw-type terminals, depending on the model.
Make sure there is firm contact with the metal, and no stray copper strands are sticking out.
Tighten or snap into place:
If it’s a screw terminal, tighten it gently with a screwdriver.
If it’s spring-loaded, push the wire in until it clicks or holds securely.
Check polarity/direction:
Boundary wires are typically not polarized, so either side can go into either terminal unless the manual specifies otherwise.
Tip:
If you're missing the original connectors, you can use standard spade connectors or ferrules for a more secure and tidy fit — available at hardware stores.
Sincerely, AiO