End caps for micro tubes Lightwin EN Standard 7–20 mm, model DC 10MM, compatible with 10 mm outer fittings

End caps by Lightwin for micro tubes in the EN standard range 7–20 mm, model DC 10MM. These end caps are designed to seal or terminate micro tubing and are compatible with fittings around 10 mm outer diameter. They protect tube ends, prevent leaks and allow safe closure of unused ports in laboratory, industrial and fluid-handling installations.

Advantages

The Lightwin DC 10MM end caps provide a precise, standardized closure for micro tubes with outer diameters near 10 mm. They are simple to install, suitable for buried or exposed applications, and reduce the risk of contamination and fluid loss. The design follows EN dimensions to ensure compatibility with EN-standard microtube fittings.

Suitable for

• Sealing or terminating micro tubes with 7–20 mm EN-standard range, especially around 10 mm OD fittings
• Protecting open tube ends during storage or transport
• Closing unused ports in laboratory and industrial fluid systems
• Applications requiring EN-standard compatible end closures

Key specifications

• Brand: Lightwin
• Model / MPN: DC 10MM END CL
• EN standard range: 7–20 mm
• Compatibility: designed for approximately 10 mm outer diameter fittings

How to use

Select an end cap matching the micro tube outer diameter (ideally around 10 mm). Push the cap onto the clean, dry tube end until it fits snugly; use the included securing clip where applicable to lock the cap in place. For buried installations ensure the cap is fully seated and secured according to site requirements. Remove by disengaging the securing clip and pulling the cap straight off the tube.

Usage recommendations

Use these end caps only on tubing and fittings within the specified EN range (7–20 mm) and compatible outer diameters near 10 mm. Inspect caps before installation for damage, and replace if deformed. For critical applications verify chemical compatibility and sealing requirements with system specifications.