Product specification Santech plumbing elbow 90° PVC model SV8046 for drainage and venting

Description
Santech plumbing elbow 90° PVC model SV8046 is a right-angle pipe fitting intended for use in drainage, wastewater and vent systems. Manufactured from rigid PVC, the elbow creates a compact 90-degree change of direction for PVC pipe runs and is suitable for rerouting wastewater flow and adapting pipe layouts in residential and commercial plumbing installations. The fitting is designed for use where a fixed, non-rotating elbow is required and is compatible with standard PVC solvent-weld or push-fit connections depending on the installation method.
Advantages
The PVC construction provides corrosion resistance and long service life in typical drainage conditions while remaining lightweight for easier handling. The 90° geometry delivers a precise directional change that simplifies layout planning and reduces the need for multiple short pipe segments. Being a standardized right-angle fitting, it enables consistent joint alignment and straightforward installation with common PVC joining techniques.
Suitable for
- Residential drainage systems (bathrooms, kitchens, utility rooms)
- Commercial wastewater and vent piping
- Pipe layout adjustments and tight corner installations
- Replacement of existing rigid 90° PVC elbows
Key specifications
- Material: rigid PVC suitable for drainage and vent applications
- Angle: 90 degrees (right-angle elbow)
- Application: drainage, wastewater and vent systems
- Connection type: compatible with standard PVC joining methods (solvent-weld or compatible push-fit)
- Typical environment: indoor plumbing and protected outdoor installations
How to use
Select the correct pipe diameter and prepare pipe ends by cutting square and deburring. Dry-fit the elbow to confirm alignment and orientation in the intended layout. For solvent-weld installations, apply appropriate PVC primer and cement to both the pipe end and fitting socket, insert the pipe fully and hold briefly to achieve a proper bond. For compatible push-fit variants, follow the push-fit manufacturer instructions to ensure full insertion and seal. Allow solvent-cement joints to cure according to the adhesive manufacturer's recommended time before system testing.
Usage recommendations
Confirm compatibility between the elbow and the pipe diameter and joining method prior to installation. Use appropriate personal protective equipment when working with solvent cements and primers. Avoid exposing the fitting to direct UV for prolonged periods unless specified as UV-stabilized, and ensure the elbow is not used in pressurized water supply lines if it is intended only for drainage or venting.