Memory Module 2-Power 2P-5M30Z71754 16 GB DDR4 3200 MHz

The 2-Power 2P-5M30Z71754 16 GB DDR4 3200 MHz memory module provides a single 16 GB DIMM designed for desktop and server systems that support DDR4 memory. With a 3200 MHz data rate and CAS latency 16, this module targets users who need increased system responsiveness and smoother multitasking. The module conforms to standard DDR4 electrical and physical specifications and is intended for straightforward installation into compatible motherboards.

Advantages

This DDR4 16 GB module delivers higher bandwidth compared with earlier DDR generations, helping reduce application load times and improving the ability to run multiple programs concurrently. CAS latency 16 balances latency and throughput at the 3200 MHz speed point, offering predictable performance for general computing and light to moderate server workloads. The module is compatible with systems that accept standard unbuffered DDR4 DIMMs and is suitable for adding single-module capacity or pairing in dual-channel configurations.

Suitable for

• Upgrading desktop PCs to increase memory capacity for everyday productivity and multimedia.
• Small office servers and workstations requiring additional RAM for multitasking and light virtualization.
• Systems configured for dual-channel memory where a 16 GB module complements an existing bank.
• Replacing a faulty or lower-capacity DDR4 DIMM in compatible motherboards.

Key specifications

• Module type: DDR4 DIMM, 288-pin form factor
• Capacity: 16 GB
• Speed: 3200 MHz (DDR4-3200)
• CAS latency: CL16
• Voltage: standard DDR4 operating voltage (1.2 V)
• ECC/Registered: standard unbuffered non-ECC configuration (verify system support)

How to use

Power down the computer and disconnect it from mains before installing the module. Open the system case to access the memory slots and consult the motherboard manual for the recommended slot population and dual-channel pairing. Align the notch on the module with the slot key, insert the DIMM at a slight angle, then press evenly until the retention clips snap into place. After installation, reconnect power and boot the system; check BIOS/UEFI to confirm the module is detected and that memory frequency and timings are set as expected. Use system tools or the operating system to verify total installed memory and run a memory test if stability concerns arise.

Usage recommendations

For best results, use this 16 GB DDR4 3200 MHz module in motherboards that explicitly support DDR4-3200 operation. Where possible, install memory modules in matched pairs for dual-channel operation to maximize bandwidth. If running RAID, virtualization, or memory-intensive server tasks, verify whether ECC or registered memory is required by your system; this module is intended as an unbuffered non-ECC option for consumer and small-business systems.