Drum ActiveJet DRX-3345N replacement for Xerox Phaser/WorkCentre (30000 pages, black)

ActiveJet DRX-3345N replacement drum unit is a compatible photoconductor designed for monochrome laser printing in Xerox Phaser and WorkCentre models. It provides a rated yield of 30,000 pages and is intended to maintain consistent black print output and reliable device performance over extended print runs. The unit replaces the original drum and supports maintenance tasks to preserve print quality in office and home environments.

Advantages

This replacement drum offers stable page yield and consistent black density across the lifespan of the unit, helping to avoid print degradation. It is manufactured to fit specified Xerox Phaser and WorkCentre models, simplifying installation and reducing downtime. The drum is suitable for extended use with monochrome printers and contributes to predictable maintenance cycles.

Suitable for

• High-volume monochrome document printing
• Office workgroups requiring consistent black output
• Printer maintenance and drum replacement intervals
• Environments where predictable print quality is required

Key specifications

• Type: Photoconductor (drum) for monochrome laser printers
• Rated yield: 30,000 pages
• Colour: Black imaging drum
• Compatible models: Designed for Xerox Phaser and WorkCentre series as specified by manufacturer compatibility

How to use

Power off the printer and follow the device manufacturer’s instructions to access the drum compartment. Remove the used drum unit according to the printer service manual, taking care to avoid contact with the drum surface. Install the replacement drum until it clicks or locks into place, then close the compartment and power the device back on. Run a test print and, if available, perform the printer’s drum alignment or calibration routine to ensure optimal print quality.

Usage recommendations

Store the drum in its original packaging in a dry, dust-free environment and avoid exposure to direct sunlight. Handle the drum by its ends and do not touch the imaging surface to prevent marks or damage. Replace the drum at the indicated lifecycle point or when print defects such as streaks or uneven density appear.