Electrical enclosure ADELID OP250350150 ABS IP65 250×350×150 mm

ADELID OP250350150 electrical enclosure is a robust ABS junction and distribution box with external dimensions 250×350×150 mm and an IP65 ingress protection rating. It is designed to house electrical components, terminal blocks and wiring while providing protection against dust and low-pressure water jets. The enclosure is suitable for wall or panel mounting and can be used in indoor and sheltered outdoor installations where a dust-tight, water-resistant enclosure is required.

Advantages

The enclosure combines impact-resistant ABS construction with an IP65 seal to protect internal components from dust and splashing or low-pressure water jets. It features a tamper-resistant lid fastening arrangement and smooth internal surfaces for straightforward cable routing and component mounting. Lightweight yet durable, the housing is suitable for quick installation and requires minimal maintenance.

Suitable for

• Protecting terminal blocks, relays and small control modules
• Junction boxes for power and signal wiring
• Wall-mounted distribution points in residential and commercial buildings
• Enclosures for sensors, meters and low-voltage control equipment

Key specifications

• Material: ABS plastic with impact resistance
• Ingress protection: IP65 (dust-tight, protected against water jets)
• External dimensions: 250 × 350 × 150 mm
• Mounting: wall or panel mounting compatible design
• Color: typically light grey (manufacturer standard)
• Finish: smooth surfaces inside for easy wiring and component fixing

How to use

Open the enclosure by loosening the external fasteners, position the enclosure onto the prepared wall or panel, and mark fixing points using the internal mounting flanges or brackets. Fix the enclosure securely with appropriate screws or anchors for the mounting surface, then route incoming and outgoing cables through prepared entry points or glands. Fasten terminal blocks and devices to the internal mounting surface or DIN rail if provided, make wiring connections following applicable electrical standards, and re-seal the lid ensuring the gasket is seated correctly to maintain the IP65 rating.

Usage recommendations

For best long-term performance, install the enclosure in a location protected from prolonged direct sunlight and extreme temperatures. Use appropriately rated cable glands or conduit fittings for all cable entries to preserve the IP65 protection. Verify that internal components do not generate excessive heat and leave adequate clearance for ventilation and service access. Regularly inspect seals and fastenings and replace the gasket if damaged.