AGAflex 90° 6-thread elbow A1 galvanized 3/4"

AGAflex 90° 6-thread elbow A1 galvanized 3/4" is a metal right-angle fitting designed for connecting pipes or hoses in fluid and gas installations. The A1 type elbow features a six-thread configuration and a galvanized finish that improves corrosion resistance and extends service life in plumbing, heating and industrial systems. The compact 90° design enables direction change in confined spaces while maintaining a mechanically secure threaded joint for straightforward assembly and disassembly.

Advantages

The galvanized surface provides protection against rust and moderate environmental exposure, reducing the need for frequent replacement in typical domestic and light industrial environments. The six-thread connection ensures a reliable mechanical seal and simplifies installation with standard tools. Its robust metal construction delivers mechanical strength suitable for pressurised fluid and gas lines while keeping a compact form factor for use in tight assemblies.

Suitable for

• Plumbing systems for potable and non-potable water lines
• Heating systems including radiators and distribution manifolds
• Compressed air and gas installations with appropriate compatibility checks
• Industrial machinery and equipment requiring right-angle pipe routing

Key specifications

• Angle: 90° elbow
• Connection type: six-thread threaded joint
• Material: metal with galvanized coating
• Nominal size: 3/4"
• Application: fluid and gas conveyance, plumbing and heating systems

How to use

Ensure the mating threads on pipes or hoses are clean and undamaged before assembly. Apply an appropriate thread sealant or tape if required by the installation standards and the conveyed medium. Screw the elbow into the mating fitting by hand until engaged, then tighten with the correct wrench size to the torque recommended for the pipe material and thread form; avoid over-tightening to prevent thread damage. Verify alignment of the run and branch after installation and perform a pressure or leak test according to local codes and system requirements.

Usage recommendations

Use this galvanized elbow in environments where moderate corrosion protection is sufficient; for highly corrosive conditions or potable water with strict approval requirements, consult compatibility guidelines and consider alternative materials or surface treatments. Regularly inspect threaded joints for signs of wear or leakage and re-tighten or replace components as needed during maintenance intervals.