AKS white channel end cap 60 x 130 | model 111453

AKS white channel end cap 60 x 130 | model 111453 is a rectangular end closure designed to finish and protect open ends of surface-mounted cable channels and trunking systems. The white finish gives a consistent, unobtrusive appearance in electrical installations and renovation projects, while the rigid profile stabilizes cable entries and helps prevent dust and debris from entering the channel.

Advantages

The end cap provides a clean visual finish and mechanical protection for exposed cable channel ends. Its dimensions (60 x 130 mm internal profile) make it suitable for medium-sized trunking runs where neat termination is required. The white color matches common cable raceway systems and simplifies installation by avoiding the need for painting or additional finishing. The part is lightweight and easy to handle, allowing quick placement and secure attachment to existing channel sections.

Suitable for

• Surface-mounted cable trunking and conduit runs where a rectangular end closure is needed
• Electrical installations in residential, commercial, or light-industrial settings
• Renovation and retrofit projects that require a matching end cap for existing white channels
• Areas where dust protection and a neat aesthetic around cable exits are important

When it may not be suitable

This end cap is intended for rectangular channel profiles measuring approximately 60 x 130 mm; it may not fit or seal properly on channels with different dimensions, rounded profiles, or nonstandard mounting systems. It is not a substitute for IP-graded enclosures and therefore may not provide sufficient ingress protection for outdoor or wet environments where a sealed, weatherproof termination is required.

Key specifications

• Shape: Rectangular end cap sized to close 60 x 130 mm channels
• Color: White finish to match typical trunking systems
• Material: Rigid plastic suitable for indoor installation and mechanical protection
• Function: Provides dust protection and a neat visual termination for cable channels
• Mounting: Designed to attach to the open end of compatible surface-mounted channels

How to use

Measure the channel opening to confirm compatibility with a 60 x 130 mm rectangular end cap. Align the end cap with the open end of the trunking and press into place until it seats securely against the channel edges. If the channel system requires screws or clips for retention, use the appropriate fasteners specified for that trunking system to secure the cap. Ensure cables are routed and secured inside the trunking before fitting the cap to avoid pinching or strain on cable connections.

What to consider before purchase

• Confirm the internal cross-section of your channel is 60 x 130 mm and has a rectangular profile
• Check whether your installation requires sealed or weatherproof end caps for outdoor or damp locations
• Verify compatibility with the mounting and retention method of your existing trunking (snap-fit, screw-fixed, etc.)

Usage recommendations

For best results, use this white end cap indoors on matching AKS or similar rectangular trunking systems sized 60 x 130 mm. Install after cable routing and secure the cap with the channel's recommended retention method. Avoid exposure to prolonged outdoor weathering without additional sealing or protection.