Alexander MAGNES LAS OP.8 SZT. (pack of 8) is a set of eight welding magnets designed to hold ferrous metal parts at fixed angles during welding, assembly and general metalworking. Each magnet provides a stable magnetic grip for positioning straight edges, corner joints and repetitive fixtures, enabling hands-free alignment and reducing the need for clamps or manual support. The compact design makes the set suitable for use in workshops, fabrication shops and on-site metal repair tasks.
Advantages
The magnets offer consistent holding force on steel and other ferrous surfaces, helping to maintain accurate angles while reducing movement during tack welding or full welds. A pack of eight allows multiple contact points or simultaneous use on several assemblies, improving workflow and repeatability. Their low-profile shape facilitates access to weld seams and corners, while the magnetic contact simplifies quick repositioning and fixture setup.
Suitable for
- Holding straight edges and plates during tack welding
- Positioning corner joints and right-angle assemblies
- Temporary fixtures for repetitive fabrication tasks
- Metalworking, repair and maintenance operations on ferrous materials
Key specifications
- Quantity in set: 8 pieces
- Material compatibility: optimized for ferrous metals (steel, iron)
- Form factor: compact, low-profile magnetic holders suitable for edges and corners
- Intended use: positioning and holding during welding, assembly and metalworking
How to use
Place each magnet on clean, flat ferrous surfaces where a stable hold is required. Align the parts to the desired angle, then position the magnet(s) to provide contact on both workpieces for secure temporary fixation. For corner joints, use magnets on adjacent faces to maintain the required geometry. Remove slag, paint or heavy rust from contact areas to ensure maximum magnetic adhesion. After welding, allow assemblies to cool before removing magnets to avoid damage or burns.
Usage recommendations
Use the magnets on clean ferrous surfaces and avoid exposing them to extreme heat for prolonged periods; they are intended as positioning aids and not as permanent fasteners. When working with small or thin sections, verify that the magnet’s holding force is sufficient before welding, and supplement with clamps if necessary. Store the set away from electronic devices and credit cards to prevent magnetic interference.
