Parking aid sensor kit Amio AMI-02290 — 4 black max LED sensors, 18 mm mounting diameter

Amio AMI-02290 is a parking aid sensor kit that includes four black Max LED reversing sensors designed for an 18 mm mounting diameter. The system combines visual LED indicators with audible alerts to assist drivers when reversing, helping to detect obstacles behind the vehicle and improving precision during low-speed maneuvers. The kit is intended for installation in the rear bumper of passenger cars and requires 18 mm holes for sensor mounting.

Advantages

The kit offers simultaneous visual and audible feedback through Max LED sensors and an integrated speaker, allowing drivers to perceive distance to obstacles quickly. Black sensor housings provide a discreet appearance when installed in dark-coloured bumpers. The sensors are designed for straightforward fitting into 18 mm drilled holes and are compatible with standard passenger car electrical systems for backup sensor installations.

Suitable for

• Passenger cars with rear bumper space for 18 mm sensor holes
• Drivers seeking both visual LED indication and audible warnings when reversing
• Urban and tight-parking environments where low-speed obstacle detection is needed

Key specifications

• Number of sensors: 4
• Sensor colour: black
• Mounting diameter: 18 mm
• Output indicators: Max LED visual display and audible alarm
• Vehicle compatibility: passenger cars (rear installation)

How to use

Prepare the rear bumper by identifying appropriate sensor positions and drill four 18 mm holes at the measured locations. Route the sensor cables through the bumper into the trunk or wiring access area and connect them to the control unit following the kit wiring diagram. Connect the control unit to the vehicle reverse light circuit and to a suitable power ground so that the system is powered automatically when reverse gear is selected. After electrical connections are made, secure the control unit in a dry location, fit each sensor into its 18 mm hole until it snaps into place, and test the system by engaging reverse gear to confirm LED indications and audible alerts operate correctly.

Usage recommendations

Prior to drilling, verify bumper material and internal structures to avoid damaging wiring, sensors, or structural components. Use the recommended 18 mm drill bit and ensure holes are clean and free of burrs before installing sensors. If uncertain about vehicle wiring or mounting, consult a professional installer to ensure reliable operation and correct integration with the vehicle’s reverse light circuit.