Signal amplifier AMS AWS-1036 — model AWS-1036, gain 20/23 dB

AMS AWS-1036 is a compact signal amplifier designed to improve reception of RF and TV signals in home and small commercial installations. The device provides selectable gain levels of approximately 20 dB and 23 dB to boost weak antenna or cable signals, reducing noise and improving picture and sound quality where signal strength is marginal. The straightforward design and modest size make it suitable for installation near antennas, distribution points, or inside equipment cabinets.

Advantages

The amplifier delivers two gain settings that allow matching amplification to signal conditions without extensive adjustments. Its compact form factor simplifies mounting in tight spaces and near signal sources. The unit focuses on increasing signal level while maintaining signal integrity, helping to reduce pixelation and audio dropouts in digital TV reception. Built for practical deployment, it requires minimal configuration and integrates with standard coaxial RF installations.

Suitable for

• Boosting weak rooftop or indoor antenna signals for better TV reception
• Improving cable signal levels in short-run distribution systems
• Placement near splitters or small distribution points to compensate for cable loss
• Use in apartments, houses, small offices or retail spaces with marginal RF signal

Key specifications

• Gain levels: approximately 20 dB and 23 dB selectable
• Application: RF/TV signal amplification for antenna and cable systems
• Form factor: compact housing suitable for near-source installation
• Connectivity: standard coaxial RF input and output (F-type or compatible)
• Power: requires external DC power supply or inline powering as per installation (check supplied documentation)

How to use

Install the amplifier close to the signal source such as the antenna or the main cable entry point to minimize loss before amplification. Connect the incoming coaxial cable to the amplifier input and route the amplified output to the distribution point or directly to the receiver. Select the appropriate gain setting (20 dB or 23 dB) based on measured signal strength or observed reception quality; start with lower gain and increase if necessary. Ensure the device receives proper power and follow grounding and safety practices for RF equipment.

Usage recommendations

For optimal results, measure signal levels before and after installation with suitable equipment or consult a technician. Avoid over-amplifying signals in environments with already strong input levels, as excessive gain can cause distortion or receiver overload. Place the amplifier as close as practical to the source and keep coaxial connections tight and corrosion-free to maintain signal quality.