Leave your address - as soon as the price of the product goes down, you'll know about it right away
Thermal pad ARCTIC TP-3 Premium Performance 100×100 mm 1.5 mm blue
Thermal pad ARCTIC TP-3 Premium Performance 100×100 mm 1.5 mm blue
In cart {{totalProductsCount}} item(s)
Your cart is empty
Thermal pad ARCTIC TP-3 Premium Performance 100×100 mm 1.5 mm blue
Leave your address - as soon as the price of the product goes down, you'll know about it right away
Thermal pad ARCTIC TP-3 Premium Performance 100×100 mm 1.5 mm blue
Thermal pad ARCTIC TP-3 Premium Performance 100×100 mm 1.5 mm blue
ARCTIC TP-3 Premium Performance is a blue thermal pad sized 100 × 100 mm with a thickness of 1.5 mm. Designed to improve heat transfer between electronic components and heatsinks, this reusable pad provides a soft, gap-filling interface suitable for CPUs, GPUs, memory modules and power components. Supplied as one pad, it simplifies mounting and helps maintain consistent thermal contact where pads are preferred over pastes.
The TP-3 pad combines moderate thermal conductivity with flexibility and reusability, allowing it to conform to irregular surfaces and fill small gaps without curing. Its 1.5 mm thickness reduces the risk of mechanical stress while maintaining reliable thermal contact. Being a single-piece pad, it is easy to place and reposition during installation.
Clean both contact surfaces to remove dust, grease or old thermal material. Cut the pad to the required size if necessary, peel off the protective film, and place the pad so it fully covers the intended contact area. Mount the heatsink or component with even pressure to ensure contact; the pad can be repositioned if needed. For best results, avoid stretching the pad when applying.
Use TP-3 where a soft, reusable thermal interface is needed or where liquid thermal compounds are unsuitable. Avoid placing the pad on exposed electrical contacts and replace it if it becomes torn, contaminated or permanently deformed.
Based on silicone and a special filler, TP-3 also outperforms high-performance pads, especially when height differences of closely spaced chips typically occur due to manufacturing tolerances. The TP-3 offers excellent thermal conductivity despite extremely low hardness.

The thinner the pad, the lower the thermal resistance. The TP-3 pad with a thickness of 0.5 mm can easily be compressed to 0.3 mm and thus compensate for height differences between various components of up to 0.2 mm. Please note that due to the extremely low hardness, installation of the 0.5 mm pad requires extra care. Please refer to the user manual.

Heat-conducting, vibration-damping, mouldable, electrically insulating — safe and easy to use. Thanks to its good compression properties, the soft heat conduction pad is particularly gentle on components and at the same time a good heat conductor. In addition to the standard format for M.2, the TP-3 is available in various sizes and thicknesses and can be easily cut to the desired shape and size. This makes it ideal for RAM, chipsets and ICs of all kinds used in PCs, laptops, consoles, graphics cards and electronic devices in general.
The ARCTIC TP-3 is electrically insulating, non-adhesive and easy to handle. This ensures optimal and safe heat transfer in many application areas.

The TP-3 pads are softer than conventional pads and therefore particularly suitable for different chip heights and manufacturing tolerances. Thanks to their good compressibility, the thermal pads act as an ideal gap filler and bridge uneven surfaces and air gaps without stressing sensitive or protruding components.

Our thermal pads are available in 0.5 mm, 1.0 mm and 1.5 mm thicknesses. The 0.5 mm variant is ideally suited as an alternative to heat-conducting foil. Pads come in different dimensions depending on thickness and can be cut to any size if required.
{{highlightedFeature.featureTitle}}:
{{getProductFeatureValueById(product, highlightedFeature.featureId)}}