AVACOM AVA-RBP04-06085-KIT is a replacement battery pack designed to restore backup power in compatible CyberPower, Eaton and Vertiv uninterruptible power supply (UPS) units. Supplied as a complete battery module, it replaces depleted or failed batteries to return the UPS to its original runtime and capacity. The pack is intended for straightforward installation into supported UPS models and helps maintain power protection for servers, network equipment and office electronics.
Advantages
The replacement battery pack provides a ready-to-install module that matches the form factor and electrical characteristics required by supported UPS models. It restores expected runtime performance, reduces downtime from battery failures, and eliminates the need to source individual cells or assemble packs. The kit simplifies maintenance by delivering a tested, factory-configured battery module compatible with common CyberPower, Eaton and Vertiv systems.
Suitable for
- Replacing worn or failed batteries in compatible CyberPower, Eaton and Vertiv UPS units
- Restoring runtime for server racks and small data centres
- Maintaining power protection for office workstations and network equipment
- Scheduled UPS maintenance and battery lifecycle replacement
Key specifications
- Function: complete replacement battery module for line-interactive and online UPS systems
- Compatibility: designed for compatibility with specified CyberPower, Eaton and Vertiv UPS models
- Form factor: pre-assembled pack matching UPS battery compartment and connector interfaces
- Purpose: restores backup runtime and capacity for connected loads
How to use
Before replacing the battery pack, power down the connected equipment according to the UPS manufacturer’s service instructions and isolate the UPS from mains power. Remove the front or rear access panel to access the existing battery module, then disconnect the battery connector and remove the old pack following safety guidelines. Install the AVACOM replacement module in the same orientation, connect the battery leads securely, close the access panel and follow the UPS manufacturer’s recommended procedure for battery recognition and calibration. After installation, verify runtime and battery status using the UPS display or management software.
Usage recommendations
Use the replacement battery pack only in UPS models listed as compatible by the UPS manufacturer. Dispose of the removed battery pack according to local regulations for battery recycling. For optimal performance, perform installation in a controlled environment with appropriate ventilation and avoid exposure to extreme temperatures or moisture.
