Mounting Clamp Avenger Klamra 8" C225 for Grip and Support

The Avenger Klamra 8" C225 mounting clamp is an 8-inch clamp engineered to provide a compact, mechanical fastening solution for lighting and rigging applications. Designed by Avenger, this clamp secures fixtures, poles and accessories to round tubes and pipes of compatible diameter. Its construction focuses on stable grip and support in studio, stage and location setups where a dependable mechanical connection is required.

Advantages

The clamp delivers reliable mechanical fastening with a compact footprint that saves space on trusses and stands. Its design allows for quick attachment and repositioning while maintaining a firm grip on round tubing. Constructed from robust materials, the clamp is intended to resist deformation under load and to provide consistent performance during repeated use.

Suitable for

• Attaching lights and small fixtures to trusses and pipework
• Securing poles, booms or short arms in studio and stage rigs
• Temporary mounting on location where fast setup and teardown are needed
• Supporting accessories such as monitors, clamps or safety lines on round tubing

Key specifications

• Clamp size: 8 inches (nominal length for gripping area)
• Intended tube compatibility: round pipes and tubing of compatible diameter
• Primary function: mechanical grip and support for lighting and rigging hardware
• Construction: metal alloy designed for structural stability under typical rigging loads

How to use

Position the clamp around the round tube or pipe at the desired location, ensuring the clamping surfaces fully contact the tubing. Tighten the clamp’s fastener(s) until a secure grip is achieved without over-torquing; the clamp should hold the attached fixture or accessory firmly in place while allowing controlled repositioning if required. Inspect the connection after installation and periodically during use to verify that fasteners remain secure and that there are no signs of slip or deformation.

Usage recommendations

Use the clamp on round tubing within the manufacturer’s compatible diameter range and observe rated load limits for the overall rigging system. Combine with appropriate safety hardware such as secondary safety cables or locks when suspending fixtures overhead or when local regulations require additional protection.