Bend 16 mm Diameter Standard Bend E-114003016 for Pipe or Conduit

Standard Bend E-114003016 for Pipe or Conduit is a fixed-radius 16 mm diameter bend designed to provide a controlled directional change for pipes, conduits and cable runs. The component supports smooth routing of tubing and cables, reduces stress at joints and helps maintain alignment in confined or structured installations. It is intended for use where a compact and reliable change of direction is required within plumbing, HVAC, electrical conduit systems and cable management assemblies.

Advantages

The 16 mm diameter and fixed-radius profile deliver predictable flow characteristics and consistent bend geometry, which simplifies installation and planning. Its compact form factor reduces the need for additional space and minimizes interference with adjacent components. The bend helps reduce mechanical stress on tubing and cable insulation at the change of direction, promoting longer service life and more reliable connections when incorporated into conduit or pipe runs.

Suitable for

• Routing small-diameter pipes and conduits in constrained spaces
• Electrical conduit systems requiring a defined directional change
• Cable management for signal, data or low-voltage wiring
• Plumbing and HVAC applications with 16 mm tubing

Key specifications

• Nominal bend diameter: 16 mm
• Bend type: fixed-radius elbow
• Function: directional change for pipe, conduit or cable routing
• Typical applications: plumbing, HVAC, electrical conduit and cable management
• Form factor: compact elbow suitable for confined installations

How to use

Position the bend at the point where a directional change is required and ensure alignment with incoming and outgoing runs. Secure the connected pipe or conduit according to the installation practice for the specific system — for example, by using compatible fittings, clamps or adhesive systems where applicable. Verify that the bend does not create excessive compression or torsion on the tubing or cable; adjust support spacing to maintain proper alignment and strain relief. After installation, inspect connections and routing to confirm smooth transitions and absence of kinks or sharp bends in adjacent runs.

Usage recommendations

Use the bend in systems with matching 16 mm tubing or conduit and follow applicable local codes and manufacturer guidance for supporting, fastening and protecting runs. Avoid forcing oversized conductors or rigid pipes through the bend; ensure cable bend radius guidelines for specific cable types are met to prevent conductor or insulation damage.