Leave your address - as soon as the price of the product goes down, you'll know about it right away
Hard Tubing Bitspower None Chamfer Brass 14mm AD, 500mm, Black Gloss
Hard Tubing Bitspower None Chamfer Brass 14mm AD, 500mm, Black Gloss
In cart {{totalProductsCount}} item(s)
Your cart is empty
Hard Tubing Bitspower None Chamfer Brass 14mm AD, 500mm, Black Gloss
Leave your address - as soon as the price of the product goes down, you'll know about it right away
Hard Tubing Bitspower None Chamfer Brass 14mm AD, 500mm, Black Gloss
Hard Tubing Bitspower None Chamfer Brass 14mm AD, 500mm, Black Gloss
Bitspower None Chamfer Brass 14mm AD, 500mm, Black Gloss is a rigid hard tubing section designed for custom PC liquid-cooling loops. Manufactured from brass and finished in a black gloss coating, this 500 mm straight tube has a 14 mm across diameter (AD) intended for use with fittings that accept 14 mm AD hard tubing. The none-chamfer profile means the tube ends are not pre-beveled, allowing compatibility with fittings and insertion methods that require a square or flat tube end for sealing or clamping.
The brass construction provides dimensional stability and resistance to bending under thermal stress compared with softer materials, while the black gloss finish offers a uniform appearance that integrates with dark-themed builds. The straight 500 mm length reduces the need for multiple joints in runs that require long straight sections. The none-chamfer end profile gives precise end-face geometry for fittings designed to clamp or compress un-beveled tube ends.
Measure and mark the required length for installation, then cut the brass hard tubing with a suitable cutting tool designed for metal tubes to ensure a clean, square end. If necessary for your fittings, carefully file or sand the tube end to the exact flatness required, taking care to remove burrs. Install the tube into fittings specified for 14 mm AD, ensuring proper seating and that seals or compression rings are correctly positioned. Test the assembled loop for leaks at low pressure before the first full system operation.
Use appropriate personal protective equipment when cutting and handling brass tubing. Verify compatibility of fittings with none-chamfer ends and 14 mm AD. For aesthetic consistency, handle the black gloss finish with soft cloths to avoid scratching; avoid abrasive cleaners. Perform a pressure or leak test after assembly and before powering the system.
{{highlightedFeature.featureTitle}}:
{{getProductFeatureValueById(product, highlightedFeature.featureId)}}