Industrial Switching Power Supply BLOW 70-572# 24V 5A 120W

The BLOW 70-572# industrial switching power supply provides regulated 24 V DC output with a maximum current of 5 A and total output power up to 120 W. Designed for continuous operation in industrial environments, this compact switching (impulse) supply is intended to feed automation equipment, control panels, instrumentation and embedded electronics that require a stable 24 V source. The unit features typical industrial protections and a compact form factor suitable for DIN-rail or panel mounting.

Advantages

The supply delivers a stable 24 V output with 5 A capacity and 120 W power in a compact housing suitable for confined electrical cabinets. As a switching (impulse) design it achieves efficient conversion with reduced heat generation compared with linear alternatives, enabling longer continuous operation and potentially lower cooling requirements. Built-in protection functions help safeguard connected loads and the supply itself during common fault conditions. Mounting options and standardized dimensions simplify integration into control panels and DIN-rail systems.

Suitable for

• Powering PLCs, controllers and industrial automation modules
• Supplying sensors, transmitters and instrumentation
• Feeding small embedded systems and single-board computers
• Providing auxiliary power for control panels and relay logic

Key specifications

• Output voltage: 24 V DC
• Maximum output current: 5 A
• Maximum output power: 120 W
• Type: industrial switching (impulse) power supply
• Mounting: DIN-rail or panel compatible compact housing
• Protection features: overcurrent/short-circuit and typical industrial protections

How to use

Install the power supply on a suitable DIN-rail or secure it to the control panel according to enclosure and mounting specifications. Connect the AC mains input in accordance with local wiring regulations and the device terminal markings, then connect the 24 V DC output to the load using appropriate cross-section wiring and secure terminals. Verify output voltage under load and confirm correct polarity before powering sensitive equipment. Ensure adequate ventilation and avoid mounting near heat sources to maintain rated performance and service life.

Usage recommendations

Use proper cable sizing and ferrules for output connections, include external fusing where required by local standards, and allow margin between supply capacity and connected load to account for inrush currents or future expansions. Regularly inspect terminal connections and ambient conditions; replace the unit if frequent protection events occur.