Wall-mount bent mast bracket with front plate BLOW 40/600 galvanized for antenna support

Wall-mount bent mast bracket BLOW 40/600 is a galvanized antenna support with a front mounting plate, designed to fix a 40 mm diameter mast at a projection of up to 600 mm from a vertical wall. The bracket provides a stable and corrosion-resistant attachment point for TV and radio antennas, satellite dishes and other outdoor aerials. Constructed for exterior use, this wall bracket is suitable for residential and light commercial installations where a secure, weatherproof mount is required.

Advantages

The bracket is galvanized to resist corrosion and extend service life in outdoor conditions. Its bent profile with a front plate ensures improved load distribution across the mounting surface, reducing stress on fasteners and the building wall. The design accommodates a standard 40 mm mast and allows a projection up to 600 mm, enabling flexible placement of antennas and dishes for optimal signal reception. The visible welded and formed joints provide predictable mechanical performance under normal wind and weather loads.

Suitable for

• Mounting TV and radio antennas on exterior walls
• Securing small satellite dishes or offset reflectors
• Installing outdoor aerials where a moderate projection from the wall is needed
• Residential and light commercial antenna supports

Key specifications

• Material finish: hot-dip galvanized steel for corrosion resistance
• Mast diameter compatibility: 40 mm
• Maximum projection from wall: 600 mm
• Mounting style: wall-mounted with front mounting plate
• Suitable environment: outdoor use, exposed to weather

How to use

Position the bracket on a suitable vertical wall surface, verify that the supporting structure can accept the load, and mark drilling points through the front plate holes. Use appropriate wall anchors or through-bolts compatible with the wall material (masonry, concrete, or timber framing) and tighten fasteners to secure the bracket flush to the wall. Insert a 40 mm mast into the bracket collar and fasten it according to the bracket’s clamping method. After mounting, attach the antenna or dish to the mast, align for optimal reception and tighten all connections. Periodically inspect fasteners and corrosion protection, re-tightening or recoating as needed.

Usage recommendations

For long-term performance, use stainless or hot-dip galvanized fasteners appropriate for the wall substrate, ensure the supporting wall has sufficient load capacity, and follow local installation regulations and antenna alignment practices to reduce wind load effects and ensure safe operation.