Wall-mount bracket BLOW 76-954# side straight 50 mm for equipment mounting

BLOW 76-954# side straight wall-mount bracket 50 mm is a compact mounting accessory designed to secure equipment and small fixtures to vertical surfaces. The bracket provides a fixed side mounting point with a 50 mm offset, creating a stable and low-profile support for pipes, conduits, cable runs or lightweight hardware in residential and light commercial installations. Constructed for straightforward attachment, it is intended to simplify routing and positioning of equipment where a narrow projection from the wall is required.

Advantages

The bracket’s straight side design and 50 mm projection deliver a defined mounting distance that helps maintain alignment and clearance from the wall. Its fixed configuration reduces play and movement once installed, contributing to a reliable support point for small-diameter pipes, conduit clips and accessory fittings. The compact footprint conserves space and enables discreet installation in confined areas or along utility runs. The product’s construction aims for durability and consistent performance under normal indoor conditions.

Suitable for

• Mounting small pipes and conduit close to vertical surfaces
• Supporting cable runs, conduit clips and wiring channels
• Fixing lightweight fixtures and hardware in residential settings
• Light commercial applications where a low-profile bracket is required

Key specifications

• Bracket type: side straight wall-mount
• Projection from wall: 50 mm
• Mounting orientation: fixed side mounting
• Use case: support for pipes, conduits, cable channels and small fixtures
• Installation: designed for attachment to vertical surfaces

How to use

Select an appropriate mounting location on a vertical surface that provides adequate structural support for the intended load. Mark and prepare attachment points using suitable fasteners for the wall substrate (for example, screws and wall anchors for plasterboard or masonry anchors for brick). Position the bracket so the 50 mm projection aligns with the required offset, secure the bracket to the wall, and then attach the pipe, conduit or fixture to the bracket using compatible clamps or fasteners. Ensure all fasteners are tightened to prevent movement and check alignment and clearance after installation.

Usage recommendations

Use fasteners and anchors appropriate to the wall material and expected load. Avoid exceeding the bracket’s intended load capacity by combining it with other supports for heavier installations. Inspect mounting points periodically for stability and re-tighten fasteners if necessary.