Power Supply BLOW EB61046953# IP67 12V 0.83A 10W for enclosure mounting, plastic housing

The BLOW EB61046953# is a mains switching power supply with IP67 ingress protection, providing a stable 12V DC output at 0.83A (10W). Housed in a sealed plastic enclosure for mounting inside junction boxes or cabinets, this unit is designed to withstand dust and temporary immersion in water, making it suitable for outdoor or damp-location installations. The compact form factor focuses on delivering low‑power, reliable DC supply for devices that require moisture resistance and a protected installation environment.

Advantages

The IP67-rated sealed construction prevents dust ingress and protects the internal electronics from water exposure, increasing reliability in wet or dusty conditions. The compact plastic housing is lightweight and simple to install inside enclosures. As a switching power supply, it offers efficient conversion from mains to 12V DC with low heat generation for its power class, and its 10W output matches a range of low‑power devices while keeping wiring and mounting requirements minimal.

Suitable for

• Low-power CCTV cameras and video accessories
• LED modules and small lighting fixtures
• Environmental sensors, detectors and transmitters
• Control electronics and low-current automation modules
• Indoor or sheltered outdoor installations where moisture resistance is required

When it may not be suitable

This 10W supply is intended for low-current loads; it is not suitable for devices requiring higher current or power beyond 0.83A. The plastic enclosure and IP67 rating offer protection against dust and water but do not replace purpose-built industrial power supplies for extreme temperature ranges, corrosive environments, or continuous heavy-duty operation. For installations requiring built-in surge protection, wide input voltage tolerance, or redundant power design, consider a higher-specification unit.

Key specifications

• Output voltage: 12 V DC
• Maximum output current: 0.83 A
• Maximum output power: 10 W
• Ingress protection: IP67 (dust-tight and protected against temporary immersion)
• Housing material: plastic
• Intended mounting: inside enclosure / junction box
• Type: mains switching power supply

How to use

Install the unit inside a suitable enclosure or junction box that provides additional mechanical protection and cable strain relief. Connect the AC mains input according to local electrical codes and the device markings, and connect the 12V DC output to the load using appropriately sized wiring to minimise voltage drop. Ensure that any cable entries are sealed and that the enclosure's IP rating is maintained after installation. Allow adequate ventilation around the unit inside the enclosure and avoid mounting directly on heat-sensitive surfaces.

What to consider before purchase

• Confirm the load current does not exceed 0.83 A and that 10 W is sufficient for your device.
• Verify that mounting inside an enclosure matches your installation requirements and that the enclosure maintains the desired IP protection.
• Check mains input voltage compatibility with local electrical supply and compliance with applicable safety standards.
• Consider cable length and wire gauge to limit voltage drop to the connected device.

Usage recommendations

Use this sealed switching supply for low‑power outdoor or damp-location equipment installed inside a properly rated enclosure. Match the output to devices that draw under 0.83 A, secure all cable glands to maintain IP protection, and follow local wiring regulations for safe and reliable operation.