Hole saw Bosch 29 mm model 2608584107 for drilling clean circular holes

Bosch hole saw 29 mm (model 2608584107) is a single-piece cutting accessory intended for making precise 29 mm diameter circular holes in materials suitable for hole saws. Designed as a one-unit cutter, it is compatible with standard arbors and drills, and is supplied as a ready-to-fit accessory for tasks that require clean round openings. The tool is intended for use where a consistent hole diameter and smooth edge are needed, such as when installing fittings, piping, cable pass-throughs and mounting hardware. Follow drill and arbor manufacturer guidance for optimal performance.

Advantages

This 29 mm Bosch hole saw delivers a consistent hole diameter and an even cut edge thanks to its single-piece construction. Its compact size makes it suitable for confined spaces and for jobs where a neat circular opening is required. The hole saw is easy to mount on a compatible arbor and offers straightforward use with common power drills. It is supplied as a single unit for simple inventory and replacement.

Suitable for

• Creating 29 mm circular holes for plumbing fittings and pipe entries
• Installing cable glands and conduit pass-throughs
• Mounting small hardware and recessed fasteners
• Creating openings in thin sheet materials and panels compatible with hole saw use

Key specifications

• Hole diameter: 29 mm
• Design: single-piece hole saw cutter
• Pack: single unit
• Compatible use: with appropriate arbor and drill
• Typical materials: wood, plastics, thin metal sheets and composite panels where hole saws are suitable (use material-appropriate speeds and cooling)

How to use

Secure the matching arbor and pilot bit in the drill, then mount the hole saw onto the arbor according to the arbor manufacturer’s instructions. Mark the center point of the required hole on the workpiece and clamp the workpiece securely. Start drilling at low speed to engage the pilot bit, then increase speed as appropriate for the material while applying steady, even pressure. Withdraw periodically for chip clearance in materials that generate a lot of waste. Follow safety practices: use eye protection, clamp the workpiece, and avoid side loads on the cutter.

Usage recommendations

For best results, select drill speeds and feed rates appropriate to the work material, use an arbor with a correctly sized pilot bit, and ensure adequate support and clamping of the workpiece to prevent vibration. When cutting metal or harder composites, use cutting fluid and moderate speeds to extend tool life; when working in wood or plastic, moderate-to-high speeds with good chip evacuation typically produce clean edges.