Drill bit SDS-plus Bosch Hammerbohrer 5X 15×100×160 mm, model 2608833822

Bosch Hammerbohrer SDS-plus 5X 15×100×160 mm is a rotary hammer drill bit designed for hammer drilling in concrete and masonry. The bit features an SDS-plus shank for secure tool engagement and rapid bit changes. With a cutting length of 100 mm and total length of 160 mm, this drill bit is intended for through and partial-depth holes in building materials commonly used on construction and renovation sites.

Advantages

The SDS-plus connection ensures firm locking in compatible rotary hammers and reduces play during impact drilling. The 5X design improves wear resistance and drilling speed in hard materials, while the optimized flute geometry removes dust efficiently to maintain cutting performance. The combination of cutting length and total length offers a balance between reach and stability for typical concrete and masonry tasks.

Suitable for

• Hammer drilling holes in reinforced and non-reinforced concrete
• Drilling into brick, blockwork and masonry
• Installation of anchors, dowels and through-fixings
• Professional construction and renovation work with SDS-plus rotary hammers
• DIY drilling tasks requiring higher impact drilling performance

Key specifications

• Shank type: SDS-plus
• Diameter: 15 mm
• Cutting length: 100 mm
• Total length: 160 mm
• Intended use: Hammer drilling in concrete and masonry
• Design: 5X wear-resistant cutting geometry

How to use

Insert the SDS-plus shank into a compatible rotary hammer until it locks. Select hammer drilling mode on the tool and apply steady axial pressure while keeping the drill perpendicular to the work surface. Start at low speed to position the tip, then maintain a consistent feed rate as the bit advances. Withdraw periodically to clear dust when drilling deep holes and allow the bit to cool during continuous use. Use appropriate personal protective equipment, including eye and hearing protection and dust extraction where applicable.

Usage recommendations

Use this drill bit with rotary hammers specified for SDS-plus bits and match the bit diameter and cutting length to the fastening or drilling task. For reinforced concrete, combine with appropriate core or rebar-cutting techniques and avoid excessive side loads to prolong bit life.