BRADAS Bohrlochmarker DIY-PCAWLSET01 — Tieflochmarker for drill holes, line width 1.0 mm, 40 pieces

BRADAS Bohrlochmarker DIY-PCAWLSET01 is a set of 40 fine-tipped deep-hole markers designed to mark drill hole centers and hard-to-reach bore points. Each marker draws a clear 1.0 mm line for precise indication on wood, metal, plaster, and many other common materials. The compact tips and consistent ink flow make these markers suitable for repeated use on construction, installation and workshop tasks that require accurate hole placement.

Advantages

The set contains 40 identical markers that deliver a consistent 1.0 mm stroke width, allowing uniform marks across multiple workpieces. Their fine tips are made for narrow or recessed holes and allow controlled marking even in limited access areas. The markers are lightweight and easy to handle, providing steady lines with minimal smudging on typical surfaces used in carpentry and installation.

Suitable for

• Marking drill centers in carpentry and joinery
• Identifying bore points in metalworking and plumbing installation
• Layout and site preparation for mounting brackets and fixtures
• DIY projects that require precise, repeatable hole marking

When it may not be suitable

These markers are intended for marking surfaces and not for measuring or permanent engraving. They may perform less predictably on highly glossy or oily surfaces where ink adhesion can be reduced. For marking on extremely fine or textured fabrics, or for applications requiring permanent chemical- or heat-resistant marks, alternative specialized markers or engraving tools should be considered.

Key specifications

• Quantity: 40 pieces per set
• Line (stroke) width: 1.0 mm
• Tip type: fine/deep-hole compatible tip
• Suitable surfaces: wood, metal, plaster, common building materials
• Packaging: compact display pack for storage and access

How to use

Shake the marker briefly before use if recommended by the manufacturer to ensure even ink flow. Position the tip at the intended drilling point and apply light, steady pressure to draw a visible 1.0 mm line or dot. For recessed or deep holes, angle the tip gently to reach the bottom of the bore point while maintaining control to avoid smudging. Replace caps after use to prevent the tips from drying out and store the set upright or in a dry place.

What to consider before purchase

• Confirm that a 1.0 mm stroke width matches your required mark size for drilling guides
• Consider the quantity of 40 pieces relative to your project size and frequency of use
• Check compatibility with the surfaces you plan to mark (porous vs. non-porous)
• Plan for storage and cap replacement to prevent drying when not in use

Usage recommendations

For best results, test a marker on a scrap piece of the same material before marking final drill points. Use a light pencil guideline if you need exceptionally precise alignment, then reinforce the point with the 1.0 mm marker to make the drilling position clearly visible.