Pipe saddle / clamp CellPack 110 mm model 5-3001 for securing and fixing round pipes

CellPack pipe saddle model 5-3001 is a 110 mm clamp engineered to secure and fix round pipes in plumbing and HVAC installations. The saddle provides stable mechanical support and alignment for pipes with a 110 mm outer diameter made of PVC, PE or similar materials. It is intended for mounting on walls, ceilings or floors where reliable fixation and simple installation are required.

Advantages

The clamp is designed for straightforward installation and durable mechanical support without introducing unnecessary complexity. Its 110 mm diameter fit is matched to common drainage and ventilation pipe sizes, offering consistent alignment and reduced movement. The product's construction supports repeated use during installation stages and provides a predictable mounting interface for brackets and fasteners.

Suitable for

• Securing 110 mm outer diameter round pipes made of PVC, PE or similar materials
• Wall, ceiling or floor mounting in residential and commercial plumbing
• HVAC duct and ventilation pipe fixation where rigid support is required
• Situations requiring simple mechanical alignment and vibration reduction

When it may not be suitable

This pipe saddle is intended for pipes with a 110 mm outer diameter; it is not suitable for pipes with significantly different diameters or for profiles that are not round. It does not provide thermal insulation or a watertight seal on its own, so additional materials should be used where sealing or thermal isolation is required.

Key specifications

• Designed internal diameter fit: for 110 mm outer diameter round pipes
• Intended pipe materials: PVC, PE or similar plastics
• Mounting options: wall, ceiling, floor attachment using appropriate fasteners
• Function: mechanical support and pipe alignment

How to use

Position the saddle around the pipe ensuring the pipe sits centrally within the clamp. Mark mounting points on the mounting surface through the saddle's fixing holes, remove the saddle, and install suitable fasteners for the surface material (e.g., masonry anchors, wood screws). Place the saddle back around the pipe and secure using the selected fasteners, tightening until the pipe is held firmly without deformation. Verify alignment and allow for any required expansion gaps according to pipe manufacturer recommendations.

What to consider before purchase

• Confirm the pipe outer diameter is 110 mm and the pipe cross-section is round
• Check compatibility with the pipe material (PVC, PE, etc.) and expected loads
• Ensure appropriate fasteners are available for the mounting surface
• Decide if additional insulation or sealing materials are needed for the application

Usage recommendations

For reliable performance, use corrosion-resistant fasteners suitable for the mounting substrate and leave a small allowance for thermal expansion of plastic pipes. Inspect clamps periodically in areas exposed to vibration or mechanical stress and replace if any deformation or loosening is observed.