Metal beam clip Celo 91211CC for beams 7.2–12 mm, for cables and conduit ø10–11 mm, pack 100

Celo 91211CC is a metal beam clip designed to hold cables and corrugated conduit with outer diameters of 10–11 mm on structural beams with flange thickness from 7.2 to 12 mm. Supplied in a pack of 100, the clip offers a mechanical fastening solution for routing power, control and data cables along metal beams in commercial or industrial installations. The clip is intended to be attached to the beam flange and provide a stable support point for single or bundled conductors and small conduits.

Advantages

The metal construction gives reliable mechanical strength and resistance to deformation under load. The clip is sized specifically for conduit and cable outer diameters of 10–11 mm and for beam flanges 7.2–12 mm, which simplifies selection and installation. Packaged in a quantity of 100, the set reduces handling time for medium-sized runs and maintenance tasks and supports consistent, repeatable fixing locations along beam runs.

Suitable for

• Fixing single cables or small cable bundles with outer diameter 10–11 mm to metal beams
• Securing corrugated conduit (peszel) with outer diameter 10–11 mm along structural beams
• Electrical routing in industrial, commercial or utility spaces where beam-flange mounting is required
• Installation and maintenance tasks that require multiple identical beam-mounted clips supplied in a pack

When it may not be suitable

This clip is not suitable for cables or conduits with outer diameters significantly different from 10–11 mm, or for beam flanges thinner than 7.2 mm or thicker than 12 mm. It is a mechanical fastener and does not provide electrical insulation or environmental sealing; additional protection should be used where moisture, corrosive conditions or electrical isolation are a concern.

Key specifications

• Compatible conduit/cable outer diameter: 10–11 mm
• Compatible beam flange thickness: 7.2–12 mm
• Material: metal (steel)
• Quantity per pack: 100 pieces

How to use

Position the clip over the beam flange so that the clip body grips the flange within the specified thickness range, then press or snap the clip into place until it sits securely on the beam. Insert the cable or corrugated conduit into the retaining loop or channel of the clip, ensuring the conductor or pipe is held without excessive deformation. Space clips along the beam at intervals appropriate for the cable type, load and applicable installation standards to avoid sagging and mechanical strain.

What to consider before purchase

• Confirm the outer diameter of the cable or conduit is within 10–11 mm
• Measure the beam flange thickness to ensure it falls between 7.2 and 12 mm
• Assess environmental conditions (corrosion, moisture) to determine if additional protective measures or treated clips are required
• Verify the required clip spacing and load capacity for your installation to ensure safe cable support

Usage recommendations

Use consistent clip spacing and align clips along the beam to create uniform cable runs. Where corrosion or exposure to aggressive environments is expected, select clips with appropriate surface treatment or apply additional protective coatings. For runs containing multiple cables, avoid overfilling the clip to prevent deformation of cable insulation.