Metal beam clip Celo 91218CC for 7.2–12 mm beams, secures cables or corrugated conduit Ø15–18 mm, pack of 100

Celo 91218CC is a metal beam clip engineered to fasten onto beams with flange thicknesses from 7.2 to 12 mm and to secure electrical cables or corrugated conduit with outer diameters of 15–18 mm. Supplied in a pack of 100, this clip offers a simple mechanical fixing for routing cables along metal supports in industrial, commercial and residential installations. The design focuses on reliable retention and compatibility with common beam profiles used in cable management runs.

Advantages

The metal construction delivers durable mechanical strength and resistance to deformation under load, while the clip geometry provides consistent clamping force for cables or flexible conduit. Supplied in a bulk pack of 100, the product supports multiple fixing points for comprehensive cable routing. The clip’s dimensions match standard beam flange widths and conduit diameters, enabling straightforward integration into existing support systems.

Suitable for

• Fastening non-armoured electrical cables or corrugated conduit (Ø15–18 mm) to metal beams with flanges 7.2–12 mm
• Cable routing along roof purlins, steel frames, rack supports and strut channels in industrial and commercial sites
• Residential installations where metal support beams are used and a mechanical cable fixing is required

When it may not be suitable

This clip is not intended for use with cables or conduits outside the stated outer diameter range (smaller than 15 mm or larger than 18 mm) as retention and fit will be compromised. It is also not designed for attachment to beams with flange thicknesses below 7.2 mm or above 12 mm, or for use as a primary support for very heavy cable bundles where specialised supports or clamps are required.

Key specifications

• Material: metal (steel)
• Compatible beam flange thickness: 7.2–12 mm
• Compatible cable / conduit outer diameter: 15–18 mm
• Pack quantity: 100 pieces
• Function: mechanical fixing for cable routing on metal supports

How to use

Position the clip over the beam flange so the beam sits within the clip’s specified flange range, then press or bend the clip into place according to the clip’s mechanical engagement method. Insert the cable or corrugated conduit into the circular retention area and ensure it is seated securely. Use one clip per desired fixing point, spacing clips according to cable weight, local regulations and installation best practices. If necessary, check that the assembled clips do not interfere with moving parts or sharp edges that could damage the cable sheath.

What to consider before purchase

• Confirm beam flange thickness is within 7.2–12 mm
• Verify cable or conduit outer diameter is 15–18 mm
• Determine required clip spacing and total quantity for the installation
• Consider environmental conditions (corrosion risk) and whether a coated or stainless alternative is needed

Usage recommendations

For safe and reliable installations, apply one clip at every structural support or at regular intervals as defined by local electrical codes and the weight of the cable run. Inspect installed clips for secure engagement and for any signs of corrosion or deformation during routine maintenance.