Plastic Sleeve Celo 91260SH SH 12-60 for Chemical Anchor 12x60 mm, pack of 24

Celo 91260SH plastic sleeve SH 12-60 is a dedicated accessory for chemical anchor installations in masonry and concrete. Sized 12 x 60 mm and supplied in a pack of 24, the sleeve provides a stable form that contains injected resin around anchor rods or bolts, promoting correct bonding and consistent embedment depth. It is intended for use where chemical anchoring systems are specified for structural or non-structural fixings in construction, renovation and repair work.

Advantages

The sleeve is manufactured from durable plastic formulated to resist common on-site conditions during installation and to maintain shape while the resin cures. Its internal diameter and length match the requirements for 12 mm anchor rods and 60 mm embedment, ensuring uniform resin distribution. Supplied in a pack of 24, it supports multiple anchor points on a single job and helps speed up repetitive installation tasks.

Suitable for

• Chemical anchoring of threaded rods and bolts in concrete and masonry
• Structural and non-structural fixings such as handrails, steel bases, and ledgers
• Retrofit and repair work where controlled resin volume and spacing are required

Когда может не подойти

The sleeve is not suitable for anchor diameters or embedment depths other than 12 x 60 mm; using it outside its specified size may compromise bond quality. It is also inappropriate for installations that require metal or mechanical protection sleeves, or where high temperatures or chemical exposures exceed the resin and plastic material limits specified by the anchor system manufacturer.

Key specifications

• Material: plastic suitable for chemical anchoring installation
• Inner diameter: sized for 12 mm anchor rod
• Length / embedment depth: 60 mm
• Pack quantity: 24 sleeves
• Application: masonry and concrete substrates

How to use

Drill the hole to the diameter and depth specified by the chemical anchor system and clean it thoroughly of dust and debris. Insert the Celo 12x60 sleeve into the drilled hole until flush with the surface or to the depth recommended by the anchor system instructions. Inject the chemical resin into the sleeve following the resin manufacturer’s mixing and dispensing procedures, then insert the threaded rod or bolt to the required depth and allow the curing period before applying load. Follow the chemical anchor system technical datasheet for hole cleaning, resin type, curing times and torque values.

What to consider before purchase

• Confirm compatibility of sleeve size (12 x 60 mm) with the anchor rod diameter and required embedment depth
• Check that the sleeve material and the chosen resin are suitable for the substrate and environmental conditions
• Ensure pack quantity (24) matches the number of anchors required for the project

Usage recommendations

For reliable results, use the sleeve together with a chemical anchor system from the same approved specification, adhere strictly to hole cleaning and resin curing guidelines, and avoid loading anchors before the resin has fully cured.