Metal beam clip Celo 9129CC for cables and conduit, beam width 7.2–12 mm, for conduit Ø8–9 mm, pack 100 pcs

Celo 9129CC is a metal beam clip engineered to fasten cables and corrugated conduit (peszla) with an outer diameter of 8–9 mm to structural beams with flange/beam widths between 7.2 and 12 mm. Supplied as a pack of 100 pieces, this clip offers a mechanical fastening solution for routing and securing cable runs in electrical installations, industrial racks, cable trays and similar mounting scenarios where a robust metal fixing is required.

Advantages

The metal construction provides mechanical strength and resistance to deformation compared with plastic alternatives, ensuring stable retention of cables and conduit. The clip’s geometry is designed for quick attachment to beams within the specified width range and for secure holding of conduits Ø8–9 mm. Supplied in a 100-piece pack, it simplifies bulk installation planning and reduces handling time on site.

Suitable for

• Fastening corrugated conduit (peszla) Ø8–9 mm to I-beams, C-channels and other beams with flange width 7.2–12 mm
• Routing and fixing cable bundles along cable trays and industrial racks
• Electrical installation works in commercial and industrial environments

When it may not be suitable

This metal beam clip is not intended for beams with flange widths outside the 7.2–12 mm range; attempting to use it on much narrower or wider flanges may result in insecure attachment. It is also not designed to directly secure very large conduit or cable bundles that exceed the stated conduit diameter or require load-bearing support; for those cases use appropriately sized clamps or support systems.

Key specifications

• Material: metal (steel)
• Compatible beam/flange width: 7.2–12 mm
• Compatible conduit outer diameter: 8–9 mm
• Pack quantity: 100 pieces
• Intended use: mechanical fastening of cables and corrugated conduit

How to use

Position the clip over the beam flange so that the clip engages the beam within the 7.2–12 mm width range. Insert the corrugated conduit (Ø8–9 mm) into the clip’s holding section until it is retained securely. Verify that the clip is fully seated on the beam and that the conduit is held without excessive movement. For series installations, plan spacing between clips based on conduit flexibility and local installation regulations to ensure continuous support.

What to consider before purchase

• Confirm the beam or flange width at the installation site is within 7.2–12 mm.
• Check the outer diameter of the conduit or cable bundle to ensure compatibility with Ø8–9 mm capacity.
• Consider environmental conditions (corrosion risk) and whether a specific metal finish or corrosion protection is required.
• Estimate required quantity taking into account spacing and potential waste; pack contains 100 pieces.

Usage recommendations

Use these clips at regular intervals along the run to prevent sagging; follow local electrical installation codes for spacing and mechanical protection of cables. Where corrosive atmospheres are present, consider additional corrosion protection or alternative materials compatible with site conditions.