Metal beam clip Celo 9759CC for cables and corrugated conduit, fits beam flange 4–7.5 mm, for cable/PEX conduit Ø 8–9 mm, pack 100 pcs

Celo 9759CC is a metal beam clip designed to fasten single cables and corrugated conduit (peszla) with outer diameters of 8–9 mm to steel or aluminium beam flanges with thicknesses between 4 and 7.5 mm. Supplied as a pack of 100 pieces, this clip provides a mechanical fixing method for routing and securing cable runs in industrial, commercial and utility installations where a robust clamp anchored to a beam flange is required.

Advantages

The metal construction offers dimensional stability and mechanical strength under static load, while the clip profile is shaped to hold cables or flexible conduit of Ø 8–9 mm firmly in place. Compatibility with beam flanges 4–7.5 mm thick allows direct attachment to common structural members without additional adapters. Supplied in a pack of 100, the set is suitable for multi-point fixing across a run and reduces handling time during installation.

Suitable for

• Securing single electrical cables of approximately 8–9 mm outer diameter
• Fastening corrugated conduit/peszel (Ø 8–9 mm) to beam flanges
• Mechanical cable routing on steel or aluminium beams with 4–7.5 mm flange thickness
• Industrial and commercial installations requiring multiple identical clamps (bulk pack)

When it may not be suitable

The clip is not intended for use with conductors or conduits outside the specified diameter range; using significantly larger or smaller cables may result in inadequate retention or damage. It is also unsuitable for beam flanges thinner than 4 mm or thicker than 7.5 mm, and should not be used as the sole support for heavy cable bundles or conduits that exceed the mechanical load capacity of a small metal clip.

Key specifications

• Compatible conduit/cable outer diameter: 8–9 mm
• Beam flange thickness compatibility: 4–7.5 mm
• Material: metal (steel)
• Quantity per pack: 100 pieces
• Mounting type: flange-clip fastening to beam

How to use

Position the clip over the beam flange so the flange seats into the clip's mounting channel, ensuring the flange thickness falls within the 4–7.5 mm range. Insert the cable or corrugated conduit into the clip's retaining loop until it sits securely. Verify that the clip engages the flange and that the cable is held without excessive deformation. For runs requiring multiple fixings, space clips at regular intervals according to local electrical installation standards to support the cable or conduit adequately.

What to consider before purchase

• Confirm the outer diameter of the cable or conduit is within 8–9 mm.
• Measure beam flange thickness to ensure it falls between 4 and 7.5 mm.
• Evaluate the number of clips needed for the length and weight of the cable run; this product is supplied in packs of 100.
• Check material compatibility if used in corrosive environments or where galvanic corrosion may occur.

Usage recommendations

Use these clips at regular intervals to maintain secure cable routing; avoid over-tightening or deforming cables during insertion. For exposed or outdoor installations, consider additional corrosion protection or alternative fittings if the environment is aggressive. Follow applicable national and local electrical installation standards for spacing and mechanical support of cables and conduits.