Twist drill bit Cimco 208356

The Cimco 208356 twist drill bit is designed for use with rotary hammers and delivers accurate, efficient drilling performance. Intended for right-hand rotation, this single-piece drill bit provides a reliable option for creating holes in a range of common construction and renovation materials. Its construction focuses on durability and consistency to meet the demands of repeated use in both professional and home workshop environments.

Advantages

This twist drill bit combines a robust build with geometry suited for rotary-hammer operation, offering stable drilling and reduced breakage risk under typical load. The right-hand rotation design matches standard rotary-hammer chucks and operating directions, enabling straightforward installation and use. As a single-unit item, it is compact to store and replace, and its material selection supports extended service life when used within recommended parameters.

Suitable for

• Drilling holes in masonry, concrete and similar hard substrates when used with a compatible rotary hammer
• General construction and renovation tasks requiring consistent hole size and alignment
• Workshop and site repairs where a durable, single-piece twist drill is needed

Key specifications

• Design type: twist drill bit for rotary hammer use
• Rotation compatibility: right-hand rotation
• Packaging: single-piece supply
• Intended use: drilling in hard substrates such as masonry and concrete when paired with an appropriate rotary hammer
• Construction: durable material and geometry for extended service life under normal working conditions

How to use

Select a rotary hammer compatible with the bit shank and ensure the tool is set to the correct operation mode for drilling (consult the tool manual). Secure the bit in the chuck according to the rotary hammer manufacturer’s instructions. Mark the drilling point, start at low speed to establish the hole, then progress to the required drilling speed and feed pressure while maintaining steady alignment. Withdraw the bit periodically to clear debris and reduce heat build-up. After use, clean the bit and store it in a dry place.

Usage recommendations

Use protective equipment such as eye protection, gloves and hearing protection when operating a rotary hammer. Match drill diameter and length to the task and avoid excessive side loads. For optimal performance in very abrasive or reinforced concrete, verify that the bit material and geometry are suitable and consider using specialist masonry or carbide-tipped bits where necessary.