Press-fit Tee Comap 20x20x20 — Comap DWZ/PWE press connector

The Comap press-fit tee 20x20x20 is a three-way press connector designed for joining equal-diameter copper or multilayer pipes using compatible press tools and jaws. Intended for plumbing and heating installations, this tee provides a reliable branch connection in residential and light commercial systems. The fitting is compatible with Comap DWZ and PWE press systems and is manufactured to deliver a consistent mechanical press joint that supports sealed, maintenance-free pipe connections when installed according to manufacturer guidelines.

Advantages

This press-fit tee offers rapid installation compared with soldering or brazing, reducing on-site work time and heat-related risks. The design ensures uniform press profiles when used with the specified DWZ/PWE press systems, producing leak-resistant joints suitable for potable water and heating circuits. Its equal-diameter configuration simplifies planning and inventory by using the same size pipe on all three branches.

Подходит для

• разводки водоснабжения в жилых домах
• монтажа систем отопления малого и среднего уровня
• соединения медных и многослойных труб одного диаметра
• быстрого выполнения ответвлений в местах с ограниченным доступом

Key specifications

• Type: press-fit tee for three-way connections
• Connection method: press fitting compatible with DWZ/PWE systems
• Nominal size: 20 x 20 x 20 mm (equal-diameter branches)
• Suitable pipe materials: copper and multilayer pipes of compatible dimensions
• Application: potable water and heating installations in residential and light commercial buildings

How to use

Prepare pipe ends by cutting square and removing burrs, then verify that the pipe outer diameter and wall thickness match the requirements for the press system. Insert the pipe fully into each branch of the tee until it seats against the stop. Use the recommended DWZ or PWE press tool and the correct jaw size for 20 mm fittings. Perform the press operation according to the press tool manufacturer’s instructions and visually inspect each joint to confirm a completed press profile. After pressing, test the system for leaks following standard commissioning procedures.

Usage recommendations

Store fittings in a dry, dust-free environment and protect connections from contamination prior to pressing. Use only approved press jaws and follow the press tool calibration and maintenance schedule. Do not apply excessive bending or torsion to joints after pressing; if pipe alignment requires adjustment, perform it before pressing. For installations involving drinking water, follow local regulations and flushing procedures before commissioning.

Keywords: Comap press-fit tee 20x20x20, Comap DWZ press connector, PWE press connector, press tee 20 mm, press fitting tee, plumbing branch connector, heating installation fitting.