Press-fitting Tee Comap 26x16x20 mm, copper fitting for plumbing (model 733JBE-02)

The Comap press-fitting tee 26x16x20 mm is a copper press tee designed for plumbing and heating installations where a reliable branch connection is required. This tee creates a secure pressed joint without the need for welding or soldering and is intended for use with compatible copper press systems. It is suitable for potable water and heating circuits and provides a compact solution for branching from a main line to a smaller-diameter feed.

Advantages

This copper press-fitting tee delivers consistent mechanical strength and leak-tightness when installed with the appropriate press tool and compatible seals. The pressed connection reduces installation time compared with traditional soldering, eliminates open flames on site, and produces repeatable joints that meet industry installation practices. Its dimensional design supports transitions between pipe sizes and helps maintain flow characteristics when creating a lateral feed.

Suitable for

• Branch connections in potable cold and hot water distribution systems
• Branching from heating supply or return lines in hydronic systems
• Repair or extension of existing copper press piping networks
• Installer use where fast, flame-free connections are required

Key specifications

• Material: copper
• Connection type: press-fitting designed for use with compatible press tools and seals
• Nominal dimensions: branch and run sizes 26 mm × 16 mm × 20 mm
• Application: potable water and heating systems
• Installation method: cold pressing (no soldering or brazing required)
• Body design: tee for creating a lateral branch from a main line

How to use

Ensure pipes are cut square, deburred and cleaned before insertion. Verify compatibility of the press-fitting tee with the press tool, jaws, and sealing element being used. Insert the prepared pipes fully into the fitting until they reach the shoulder, then perform the press operation according to the press tool manufacturer’s instructions to create the permanent joint. After pressing, visually inspect the formed press profile for correct closure and ensure the system is pressure-tested following relevant standards and local codes.

Usage recommendations

Use only approved press tools, compatible jaw sizes and seals specified for copper press fittings. Follow local plumbing and heating regulations during installation and perform pressure testing before commissioning the system. Store fittings in a dry environment to avoid contamination and handle with care to prevent damage to the mating surfaces.