Compression sleeve connector Comap TurboSKIN 20-16 — screw-type red sleeve

Compression sleeve connector Comap TurboSKIN 20-16 — screw-type red sleeve is a compact transition fitting designed to join 20 mm to 16 mm pipes or fittings with a sealed mechanical connection. The red screw-type sleeve provides a confined footprint for installations with limited space and is intended for plumbing and heating circuits where a reliable hydraulic seal and mechanical strength are required. The sleeve is engineered for a straightforward installation that results in a leak-resistant joint when properly tightened.

Advantages

The screw-type design enables consistent mechanical compression and a controlled sealing action without the need for special tools beyond standard wrenches. Its compact body reduces the installation length needed for a transition between pipe sizes, and the red finish improves visual identification on manifolds and piping runs. The sleeve construction delivers a combination of mechanical retention and hydraulic sealing suitable for pressurized potable water and heating systems when installed according to applicable codes.

Suitable for

• Transition connections between 20 mm and 16 mm pipes in domestic plumbing
• Branching and size reduction on heating circuits and radiators
• Compact installations behind cabinets, in manifolds, and tight technical spaces
• Maintenance and retrofit work where a reliable sealed joint is required

Key specifications

• Connection type: screw-type compression sleeve for mechanical and hydraulic sealing
• Pipe size transition: from 20 mm to 16 mm
• Finish: red
• Designed use: plumbing and heating installations
• Installation: requires standard tightening tools (wrenches)

How to use

Ensure both pipe ends are clean, free of burrs and properly cut square. Slide the sleeve components onto the pipe ends as required, insert the 16 mm and 20 mm pipes into their respective ports, and hand-start the screw engagement. Tighten the screw-type sleeve with appropriate wrenches following the manufacturer’s recommended torque steps or until the compression creates a visible sealed joint. After tightening, pressurize the system and inspect the joint for leaks. If any seepage is observed, retighten within recommended limits or disassemble and re-seat the pipes before repeating the compression step.

Usage recommendations

Use the connector only on compatible pipe materials and sizes (20 mm to 16 mm) and follow local plumbing and heating installation rules. Avoid over-tightening to prevent damage to pipe ends or sealing elements. For concealed or buried installations, verify material compatibility and accessibility for future maintenance.