Copper 45° bend connector Conex series 5000 double-socket 18 mm

Copper 45° bend connector Conex series 5000 double-socket 18 mm is a precision-formed copper fitting intended for creating a 45-degree change of direction between two copper pipes with an 18 mm outer diameter. Manufactured to Conex series 5000 tolerances, the double-socket design accepts pipe ends on both sides to form a continuous line with a single joint at each end. The fitting is suitable for use in plumbing and heating installations where a compact angled connection is required and can be joined by soldering or by compatible mechanical press systems, depending on the chosen installation method.

Advantages

The connector provides a consistent 45° angle with smooth internal contours to reduce flow disturbance and minimize pressure loss. Its copper construction offers corrosion resistance and thermal conductivity appropriate for potable water and central heating circuits. The double-socket configuration simplifies alignment of two pipe ends and allows secure joints using conventional soldering techniques or approved press systems, providing installation flexibility for different jobsite conditions.

Suitable for

• Plumbing installations carrying potable water
• Heating circuits and radiators
• Directional changes in domestic and light-commercial pipework
• Replacement or repair of existing copper runs

Key specifications

• Material: copper
• Angle: 45°
• Connection type: double-socket for end insertion
• Nominal pipe size: 18 mm outer diameter
• Joining methods: soldering or compatible mechanical press-fit systems

How to use

Prepare the copper pipe ends by cutting square and deburring both the internal and external edges to ensure full insertion into the sockets. Clean the mating surfaces to remove oxide and contaminants if soldering; apply appropriate flux, assemble the joint and heat evenly until solder flows to create a continuous seal. If using a press-fit system, follow the press tool and jaw manufacturers instructions for insertion depth and pressing sequence to achieve a certified mechanical joint. Verify alignment and support the pipe runs to prevent strain on the fitting after installation.

Usage recommendations

Use compatible cleaning, flux, solder or press-tooling materials approved for potable water systems. Ensure accessible orientation and avoid excessive bending near the fitting. For systems operating above standard temperatures or pressures, consult applicable codes and select fittings and joining methods rated for those conditions.