Conex gas press tee 15 mm / 200 mm — Conex IBP PRESS GAS TROJNIK

Conex IBP PRESS GAS TROJNIK is a press-fit gas tee designed to connect a 15 mm main run with a 200 mm branch for gas distribution systems. Engineered for use with compatible press tools, this fitting creates a mechanical joint intended for domestic and light commercial gas installations. The design supports reliable, leak-resistant connections when installed according to applicable standards and with appropriate gas-rated piping and tools.

Advantages

This press gas tee provides a consistent mechanical connection that reduces the need for flame-based joining techniques and speeds up installation. Its geometry is optimized for press-tool engagement, delivering uniform compression and a secure joint when pressed correctly. The fitting is manufactured to suit gas-service requirements and is compatible with common press systems used in professional plumbing and heating work.

Suitable for

• Domestic natural gas distribution lines with 15 mm mains and a 200 mm branch
• Light commercial gas installations requiring press-fit connections
• Repair or modification of existing gas piping where a 200 mm outlet is needed
• Projects prioritising mechanical press connections instead of soldering or welding

Key specifications

• Connection type: press-fit tee for gas applications
• Main run diameter: 15 mm
• Branch length: 200 mm
• Application: gas distribution (domestic and light commercial)
• Compatibility: designed for use with compatible press tools and gas-rated pipe

How to use

Ensure all components and tools are rated for gas service and comply with local codes. Prepare the pipe ends by cutting squarely and deburring to the required insertion depth. Insert the pipe fully into the press tee until the correct stop is reached. Position the press tool jaws so they align with the designated press zone on the fitting and operate the tool according to the manufacturer's instructions to achieve a complete press cycle. After pressing, inspect the joint visually and perform leak testing in accordance with applicable gas safety procedures before placing the system into service.

Usage recommendations

Use only press tools and jaws recommended by the press system manufacturer, and follow local regulations for gas installations. Perform pressure and leak tests after installation, and do not use this fitting with fluids or gases for which it is not certified. Engage qualified personnel for installation and inspection when required by local codes.