Tee fitting Conex IBP PRESS GAS 22 mm x 100 mm

The Conex IBP PRESS GAS 22 mm x 100 mm tee fitting is designed for creating branch connections in gas distribution systems using press-fit technology. This fitting is intended for use with copper or compatible press-connection pipe systems and provides a gas-rated, mechanical joint suitable for professional plumbing and gas service applications. The 22 mm main run and 100 mm branch length accommodate common layouts where a lateral feed or sub-branch is required.

Advantages

This press gas tee offers a consistent, repeatable press connection that reduces the need for open flames or soldering during installation. The design supports sealed, gas-rated joints when installed with recommended press tools and compatible rings, helping to ensure system integrity. Manufactured by a recognized brand for plumbing fittings, the tee is dimensioned for standard 22 mm pipework and provides a long branch offset for flexible routing.

Suitable for

• Gas distribution systems using copper or compatible press-fit pipes
• Branching off mains to supply appliances or sub-runs
• Professional plumbing and gas service installations
• Situations requiring flame-free press connections

Key specifications

• Connection type: press-fit
• Material compatibility: copper and compatible press-connection pipes
• Main diameter: 22 mm
• Branch length/offset: 100 mm
• Application: gas-rated fitting for distribution systems

How to use

Prepare the pipe ends by cutting square and deburring to ensure a clean surface. Slide the appropriate gas-rated press ring onto the pipe, insert the pipe fully into the tee until the stop, and position the press tool over the fitting according to the tool manufacturer’s instructions. Perform the press operation at the specified location on the fitting, then inspect the joint visually and, where applicable, test the system for leaks in accordance with local gas installation regulations and standards.

Usage recommendations

Use only approved gas-rated press rings and compatible press tools; follow local codes and the fitting manufacturer’s installation guidelines. Verify material compatibility and system pressure ratings before installation and perform leak testing after assembly.