PLA+ 3D Printer Filament Creality 1.75 mm White 1 kg for Ender 3

Creality PLA+ 1.75 mm filament, 1 kg spool in white is a general-purpose 3D printing material designed for reliable everyday use with Ender 3 and other FDM printers that accept 1.75 mm filament. PLA+ is a modified PLA formulation that offers higher toughness and reduced brittleness compared with standard PLA while retaining ease of printing on common Bowden and direct-drive extruders. This filament is intended for producing functional prototypes, household parts and detailed models where a balance of printability and mechanical performance is required.

Advantages

PLA+ provides improved impact resistance and greater layer adhesion relative to conventional PLA, resulting in parts that are less prone to cracking or snapping under stress. The material prints at moderate temperatures and typically requires no heated enclosure. It produces consistent flow from the 1 kg spool and is available in a neutral white colour that is suitable for post-processing such as sanding, painting or gluing. Because it prints well on both Bowden and direct-drive systems, it fits a wide range of consumer and prosumer printers.

Suitable for

• Functional prototypes and mechanical parts with moderate stress
• Household items, fixtures and mounting brackets
• Detailed scale models and display pieces requiring clean surface finish
• Educational projects, rapid iteration and everyday printing tasks

Key specifications

• Filament diameter: 1.75 mm
• Spool weight: 1 kg (net material)
• Material type: PLA+ (modified polylactic acid)
• Colour: White
• Compatibility: FDM/FFF printers accepting 1.75 mm filament, including Ender 3 series
• Printing behaviour: Improved toughness, reduced brittleness, good layer adhesion

How to use

Load the 1.75 mm PLA+ filament onto your printer spool holder and feed it into the extruder according to the printer manufacturer's instructions. Typical nozzle temperatures for PLA+ range from 190°C to 220°C; start in the middle of this range and adjust based on extrusion consistency and surface appearance. A heated bed set between 50°C and 60°C can help first-layer adhesion; use blue tape or a PEI sheet if needed. Print at moderate speeds (e.g., 40–60 mm/s) for reliable results, and calibrate retraction settings to minimize stringing when using Bowden setups.

Usage recommendations

Store the filament in a dry environment or sealed bag with desiccant to prevent moisture absorption. For parts requiring higher impact resistance, consider increasing wall thickness or infill percentage rather than raising print temperature. When finishing, sand carefully and apply appropriate primers or paints compatible with PLA-based materials.