Build Plate Creality 370x370 mm Frosted Surface for K2 Plus 3D Printer

Replacement build plate for Creality K2 Plus 3D printer with a frosted textured surface and dimensions 370 x 370 mm. Designed to fit the K2 Plus build area, this plate improves first-layer adhesion and provides a stable, flat printing surface for general FDM printing tasks. Although made for the Creality K2 Plus, it also fits other printers that use a 370 x 370 mm print bed.

Advantages

The frosted surface resists scratches and damage while offering ultra-high adhesion for more stable molding and improved first-layer consistency. The plate maintains exceptional flatness to ensure even prints and makes model removal easier thanks to its textured finish. It is compatible with a wide range of filaments including PLA, ABS, ASA, PETG, TPU, PC and PA. Note: this is an aftermarket replacement and differs from the original K2P plate; the non-original version does not include the clean nozzle design in the non-printing area, which does not affect printing performance.

Suitable for

• Creality K2 Plus 3D printers with a 370 x 370 mm bed
• Other FDM printers using a 370 x 370 mm build plate
• Printing with PLA, ABS, PETG, TPU, PC, PA and similar filaments
• Prototyping and small-batch production where consistent bed adhesion is required

Key specifications

• Compatibility: Creality K2 Plus and other 370 x 370 mm beds
• Dimensions: 370 x 370 mm
• Surface: Frosted / textured finish
• Material compatibility: PLA, ABS, ASA, PETG, TPU, PC, PA, etc.
• Type: Aftermarket replacement (MPN CRE-4004090129)

How to use

Warm the bed to the appropriate temperature for the filament you are using, clean both the plate and nozzle area before printing, then mount the plate on the printer’s build platform following your printer’s instruction for securing replacement plates. Level the bed or run an auto-level sequence if available, and start printing. After printing, allow the plate to cool slightly to facilitate model removal from the textured surface.

Usage recommendations

For best results, set the first-layer temperature and Z-offset according to the filament manufacturer’s guidance and perform a test print after installation. If using flexible filaments (TPU), use lower retraction and slower speeds. Avoid attempting to modify the non-printing area; the aftermarket plate lacks the clean nozzle zone present on the original K2P design but will not affect normal printing operations.