Power inlet cable assembly Dell FWGMM, 1.5 m length, compatible power inlet connection

Power inlet cable assembly Dell FWGMM, 1.5 m length, compatible power inlet connection is a replacement cable intended to connect compatible equipment to a standard power inlet. The cable provides a fixed 1.5 metre length for routing between the power inlet on a device and a nearby power source. It is produced to match the physical and electrical connection requirements of compatible Dell systems and similar devices.

Advantages

The cable offers a standardized connector interface for straightforward connection to compatible power inlets and a set length that simplifies installation planning. Constructed with insulated conductors and a moulded connector, it reduces the risk of loose contacts and supports consistent power delivery for connected equipment. Its compatibility-focused design enables quick replacement or spare-part use without the need to rewire existing setups.

Suitable for

• Replacing a worn or damaged inlet cable on compatible Dell devices
• System maintenance and service spare for IT equipment
• Setting up test benches or temporary installations requiring a 1.5 m inlet connection
• Integrating into rack-mounted equipment where a fixed cable length is preferred

Key specifications

• Cable length: 1.5 m
• Connector type: compatible power inlet connector (moulded cable end designed for standard inlet interface)
• Conductor insulation: insulated multi-core cable suitable for mains voltage
• Current rating: suitable for typical equipment power draw (designed to meet device power requirements)
• Construction: moulded connector and strain-relief at inlet end

How to use

Ensure the device and power source are powered off before connecting the cable. Align the moulded connector with the power inlet on the device and insert fully until it seats securely. Route the cable to avoid sharp bends and prevent strain on the connector; use cable clips or ties if needed to secure the run. When disconnecting, grip the moulded connector rather than pulling the cable itself to avoid damaging the termination.

Usage recommendations

Use this cable only with compatible equipment and standard mains power installations. Inspect the cable periodically for damage to insulation or connectors and replace if wear is visible. Avoid exposing the cable to liquids, excessive heat, or mechanical crushing. For installations requiring different current ratings or lengths, select a cable that matches the specific electrical and safety requirements of the equipment and local regulations.