Coaxial cable DELOCK 90699 with HSD Z to RJ-45 connectors, 1 m, black/blue

The DELOCK 90699 coaxial cable is a 1 m lead with an HSD Z male straight connector on one end and an RJ-45 female straight connector on the other. It is designed for linking devices that require conversion between HSD Z and RJ-45 interfaces, commonly used in vehicle electronics and equipment wiring. The cable is supplied as a single unit in a polybag and combines a compact HSD Z connection with a standard RJ-45 socket.

Advantages

The cable provides a direct connection between HSD Z and RJ-45 interfaces in a short, flexible 1 m length, simplifying installations where space is limited. Its two-color (black/blue) jacket supports easy identification, while the straight HSD Z male and straight RJ-45 female connectors ensure compatibility with matching ports without additional adapters.

Suitable for

• Connecting HSD Z-equipped modules to devices with RJ-45 sockets
• Automotive electronics wiring and in-vehicle data links
• Equipment assemblies and short interconnect runs in control systems

When it may not be suitable

This 1 m cable is not intended for long-distance signal transmission; for runs longer than one metre consider a longer cable or a different interface better suited to your signal and distance requirements. It is also not a general-purpose Ethernet patch cable and should only be used where HSD Z to RJ-45 connectivity is specifically required.

Key specifications

• Cable length: 1 m
• Color: black and blue jacket
• Impedance: 100 Ω
• Connector A: HSD Z male, straight
• Connector B: RJ-45 female, straight

How to use

Insert the HSD Z male connector into the corresponding HSD Z port and mount the RJ-45 female connector onto the mating RJ-45 plug or module. Ensure connectors are fully seated and secured to maintain signal integrity. Route the cable to avoid sharp bends and mechanical stress; for vehicle installations, fasten it with appropriate clips or ties to prevent movement during operation.

What to consider before purchase

• Confirm that your devices require an HSD Z to RJ-45 connection rather than a different interface
• Verify that a 1 m length is sufficient for your installation
• Ensure 100 Ω impedance is compatible with your signal requirements

Usage recommendations

For reliable performance, use this cable only between matched HSD Z and RJ-45 ports, avoid excessive bending near the connector ends, and secure the cable in vehicle installations to minimise strain and potential connector wear.