Compression connector / fitting Detal-met MGW32X1, PP, female threaded 32 mm x 1"

Detal-met MGW32X1 is a polypropylene (PP) compression connector with a female threaded outlet sized for 32 mm pipe to 1" thread conversion. The fitting is intended for joining plastic or transition piping systems, providing a standard female thread for attaching valves, adapters or other threaded fittings. It is suitable for potable water, heating and general utility lines where a compact, chemically resistant PP connector with a 1-inch female thread is required.

Advantages

The connector is manufactured from polypropylene, offering chemical resistance and low weight compared with metal alternatives. Its compression design allows a secure mechanical seal to 32 mm plastic pipes without the need for solvent welding or complex tools. The integrated female thread provides a convenient, standardized connection point for valves and accessories. The fitting resists corrosion and scale, and its smooth internal surfaces support steady flow and simple maintenance.

Suitable for

• Domestic and commercial potable water lines
• Heating circuits and radiator connections where a 1" female thread is required
• Utility and service installations combining plastic pipework with threaded valves or meters
• Repair or modification of existing plastic pipe systems

Key specifications

• Material: polypropylene (PP)
• Connection type: compression fit for 32 mm pipe
• Thread type: female 1" thread
• Suitable media: potable water, heating fluids, general utility liquids
• Operating temperature range: typical for PP plumbing fittings (check system requirements)

How to use

Prepare the 32 mm pipe by cutting squarely and deburring the end. Slide the compression nut and retention components onto the pipe according to the manufacturers orientation, insert the pipe fully into the connector body until it reaches the internal stop, and tighten the compression nut to form a secure seal. Attach the threaded valve or fitting to the 1" female thread using appropriate thread sealant or tape where required for the application. Verify alignment and test the joint for leaks under system pressure before final commissioning.

Usage recommendations

Use with compatible 32 mm plastic pipes of specified SDR or wall thickness and ensure thread sealing materials are suitable for potable water if used on drinking water systems. Do not expose the fitting to temperatures or pressures beyond the limits of polypropylene; refer to system design standards for maximum allowable operating conditions. For long-term reliability, follow periodic inspection and maintenance practices appropriate to the installation environment.