TV Splitter DigiSat SP46 1x6, 1 input to 6 outputs, model 302

The DigiSat SP46 1x6 TV splitter (model 302) distributes a single coaxial television signal to six outputs, enabling connection of multiple TVs or receivers from one antenna or cable feed. Designed for terrestrial and cable TV installations, the splitter provides a compact passive solution for small homes, apartments, or light commercial setups where signal splitting is required without built-in amplification. The device is intended to maintain signal flow to all connected outlets while fitting into a wall socket or equipment cabinet as part of a distribution setup.

Advantages

The splitter offers a straightforward and compact way to share one incoming coaxial signal across up to six devices without active power. Its passive design means no external power supply is required, which simplifies installation and reduces points of failure. The metal housing and standardized F-type connectors ensure durable physical connections and consistent impedance matching for typical TV frequency ranges used in terrestrial and cable networks.

Suitable for

• Home installations where one antenna or cable feed must service multiple TVs or set-top boxes
• Small apartments or multi-room living spaces requiring signal distribution
• Small commercial environments such as waiting rooms or small offices with basic TV needs
• Temporary setups where a simple, non-amplified split of signal is needed

Key specifications

• Configuration: 1 input to 6 outputs (1x6)
• Connector type: coaxial F-type connectors
• Design: passive splitter (no external power)
• Intended use: terrestrial and cable TV signal distribution
• Housing: compact metal enclosure suitable for installation in cabinets or behind equipment

How to use

Connect the incoming coaxial cable from the antenna or cable feed to the splitter’s input connector, then connect coaxial cables from the six output connectors to each TV or receiver. Ensure connectors are tightened securely but not over-torqued to avoid damaging threads. Because the unit is passive, there is no power connection; verify signal levels at each receiver and, if signals are weak, consider using a distribution amplifier or moving the splitter closer to the signal source.

Usage recommendations

Use quality coaxial cables and properly shielded connectors to minimize signal loss. For installations with long cable runs or low incoming signal strength, evaluate the need for an inline amplifier or a powered distribution amplifier to maintain satisfactory reception on all connected devices.