Dymo ELEMENT T-PIECE KST-200 R=300 HDG – steel T-piece for KST-200 system, radius R=300, hot-dip galvanized

Dymo ELEMENT T-PIECE KST-200 R=300 HDG is a steel T-piece designed to connect and branch runs within the KST-200 system. The component features a defined curvature radius of R=300 and a hot-dip galvanized surface finish that increases resistance to corrosion and outdoor exposure. It is intended for use where a rigid, load-bearing T-connection is required in structural, conduit or ducting assemblies that use the KST-200 profile.

Advantages

The T-piece is made from steel and finished by hot-dip galvanizing to provide a uniform protective zinc layer that improves long-term corrosion resistance. Its geometry matches the KST-200 profile family and the specified R=300 curvature ensures consistent alignment and reduced stress at the joint. The robust construction supports mechanical loads and repeated assembly or maintenance operations without rapid wear.

Suitable for

• Creating a rigid T-connection in KST-200 based structural framing
• Routing and branching conduit or duct runs where a defined curvature is required
• Indoor and outdoor installations that demand enhanced corrosion protection
• Industrial or utility installations requiring durable metallic fittings

When it may not be suitable

This T-piece is not intended for systems that are incompatible with the KST-200 profile dimensions or connection method. It may not be appropriate where non-metallic, non-galvanized, or electrically insulating fittings are specifically required. For applications expecting chemical exposure beyond general atmospheric corrosion (for example strong acids or chlorides), alternative materials or coatings should be considered.

Key specifications

• Material: steel
• Finish: hot-dip galvanized
• Profile compatibility: KST-200 system
• Curvature radius: R=300
• Connection type: T-piece for branching runs

How to use

Install the T-piece by aligning it with the KST-200 profiles or conduits to be joined, ensuring the R=300 curvature matches the intended routing geometry. Fasten using the appropriate hardware and methods specified for the KST-200 system to secure mechanical connection and load transfer. Verify alignment and clearance before final tightening, and perform any required surface cleaning or touch-up of the galvanized finish if cutting or drilling is necessary on site.

What to consider before purchase

• Ensure compatibility with the KST-200 profile dimensions and connection method
• Confirm that a hot-dip galvanized steel fitting meets the corrosion resistance requirements of the environment
• Check that the R=300 curvature is suitable for the routing geometry of your installation
• Verify load and mechanical requirements for the intended application

Usage recommendations

Use this T-piece with hardware and assembly practices recommended for the KST-200 system; for outdoor or coastal installations consider additional corrosion protection measures and periodic inspection to maintain service life.