LED Driver ECOLIGHT2 EC79608 IP67 30W 12V — Hermetic LED Power Supply

The ECOLIGHT2 EC79608 IP67 30W 12V hermetic LED power supply is a sealed low-voltage driver designed to deliver stable 12V DC output for LED strips, modules and compact fixtures. With an IP67-rated housing it provides dust-tight protection and resistance to temporary immersion, making it suitable for damp indoor areas and exposed outdoor installations where a compact, weatherproof 12-watt-class power source is needed. The unit offers 30 watts of continuous output in a compact enclosure intended for installations that require reliable, constant-voltage supply and enhanced environmental protection.

Advantages

The sealed construction and IP67 rating protect internal electronics from dust and water ingress, reducing the risk of failure in humid or wet conditions. The 12V constant-voltage output supports a wide range of low-voltage LED products and simplifies wiring for multi-point LED runs. Its 30W power capacity covers typical LED strip runs and small module arrays while the compact form factor allows installation in confined or protected locations.

Suitable for (tasks / use cases)

• Powering 12V LED strips for cove, under-cabinet or accent lighting
• Outdoor signage and architectural accent lighting exposed to rain or moisture
• Illuminating small LED module arrays for facades, shop windows or display cases
• Use in damp utility spaces such as basements, garages or covered terraces

When it may not be suitable

This 30W driver is intended for low-voltage, constant-voltage LED loads; it is not designed for high-power LED fixtures that require higher wattage or constant-current drivers. Applications that demand remote mounting with extensive heat dissipation or where electrical codes require accessible enclosures for servicing may need an alternative solution.

Key specifications

• Output voltage: 12 V DC
• Output power: 30 W (continuous)
• Protection rating: IP67 (dust-tight and temporary immersion)
• Type: sealed/hermetic constant-voltage LED driver
• Typical application: LED strips, modules and small fixtures

How to use

Install the driver in a location that meets the required ventilation and mounting recommendations for sealed enclosures; secure the unit using appropriate fasteners and route supply and load cables through suitable glands or waterproof connectors. Connect the AC input to the mains supply following local electrical regulations and connect the 12V DC output to the LED load, observing polarity. Verify total connected LED wattage does not exceed 30W and allow for a small safety margin. After wiring, test the installation for correct output and check seals and cable entries for water-tight integrity.

What to consider before purchase

• Confirm total LED load does not exceed 30W continuous
• Ensure 12V constant-voltage is compatible with your LED modules or strips
• Plan cable glands and connector types suitable for IP67 sealing
• Check local electrical codes for installation of sealed power supplies

Usage recommendations

For best long-term performance, use with LED loads that do not continuously draw the maximum rating, provide adequate mounting support to avoid mechanical stress on seals, and inspect seals and connectors periodically when installed outdoors or in aggressive environments.