Sensor Electro Base SensoIRIS T110 — wireless environmental sensor module

Electro Base SensoIRIS T110 — wireless environmental sensor module is a compact SensoIRIS series device designed to monitor ambient conditions and deliver measurement data to compatible SensoIRIS systems. The module connects wirelessly to a SensoIRIS-compatible gateway or controller and reports environmental parameters for smart home and building automation scenarios. Its small form factor allows discreet mounting in rooms, corridors or technical spaces while supporting remote data collection and alerting through the integration platform.

Advantages

The SensoIRIS T110 provides reliable wireless sensing with low power consumption and straightforward integration into SensoIRIS ecosystems. Its compact design permits flexible placement without occupying significant space. The device supports regular reporting intervals and event-driven transmissions to ensure timely information for monitoring and automation tasks. Firmware and protocol compatibility with SensoIRIS-controlled systems simplifies setup and maintenance.

Suitable for

• Room environment monitoring in residential and commercial buildings
• Integration with smart home automation and climate control systems
• Building management systems and remote condition monitoring
• Data collection for energy efficiency and indoor comfort analysis

Key specifications

• Wireless connectivity compatible with SensoIRIS network protocols
• Compact enclosure suitable for wall or surface mounting
• Low power design for extended battery life
• Environmental parameter sensing (temperature and/or additional conditions as supported by model)
• Periodic reporting and event-triggered transmissions
• Operating conditions suitable for indoor installations

How to use

Install the Electro Base SensoIRIS T110 at a representative location for the parameter you intend to monitor, avoiding direct sunlight, heaters or ventilation outlets that could bias readings. Mount the device on a flat surface or wall using screws or adhesive as appropriate for the chosen location. Pair the sensor with a SensoIRIS-compatible gateway or controller following the gateway’s device enrollment procedure. Configure reporting intervals and alarm thresholds in the management interface to suit the monitoring needs. Periodically verify signal strength and replace or recharge power source according to system notifications.

Usage recommendations

For accurate and consistent measurements, place the sensor at typical occupant height (about 1–2 meters above the floor) away from direct heat or airflow sources, and ensure the gateway is within reliable radio range. Use the platform’s configuration options to set appropriate reporting frequency and alarm levels for your environment.