Surface-mounted enclosure ELEKTROPLAST PK-5 IP55 130×130×82 mm without insert (0252-00)

Surface-mounted enclosure ELEKTROPLAST PK-5 is a compact, IP55-rated enclosure with external dimensions 130×130×82 mm designed for housing electrical components in areas that require protection against dust and low-pressure water jets. The enclosure is supplied without an internal insert, allowing flexible assembly of terminals, small control modules or cable joints. Its surface-mounted design enables quick installation on flat walls or panels for both indoor and sheltered outdoor applications.

Advantages

The enclosure provides reliable protection with an IP55 ingress rating, offering resistance to dust and splash water. Its compact footprint and moderate depth make it suitable for tight installation spaces while still accommodating common terminal blocks and small control electronics. The surface-mounted format simplifies mounting and wiring access, and the absence of a pre-installed insert gives freedom to customize internal layouts according to specific wiring or component needs.

Suitable for

• Junctions and cable terminations in residential and commercial installations
• Mounting small control modules, relays or terminal blocks
• Surface-mounted electrical connections on walls and service panels
• Protected outdoor or indoor locations where dust and water spray resistance is required

Key specifications

• Protection rating: IP55 against dust ingress and water jets
• External dimensions: 130 × 130 × 82 mm
• Mounting type: surface-mounted (wall/panel)
• Supply condition: delivered without internal insert to allow custom assembly
• Intended for housing terminals, small modules, and cable connections

How to use

Install the enclosure on a flat, stable surface using appropriate fasteners for the substrate. Route incoming cables through suitable entry points and secure them with strain relief or cable glands compatible with the enclosure openings. Fit terminal blocks, relays or other components inside the enclosure as required and make electrical connections according to applicable wiring diagrams and safety standards. After assembly, ensure the cover is properly seated and fastened to maintain the IP55 protection. Verify that any sealing elements or gaskets are correctly positioned and intact.

Usage recommendations

For best performance, use compatible cable glands and strain reliefs rated for IP55 or higher, and avoid mounting the enclosure in locations with continuous high-pressure water exposure. Periodically inspect gaskets and fasteners and replace damaged sealing elements to preserve ingress protection over time.