Surface-mounted Junction Box ELEKTROPLAST LUX-60X60/TI/EPN IP41 60×60 mm

Surface-mounted junction box ELEKTROPLAST LUX-60X60/TI/EPN IP41 60×60 mm is a compact enclosure intended for protecting electrical splices, terminations and small terminal blocks in indoor installations. The 60×60 mm footprint and surface-mounted design allow installation on walls or ceilings in residential and light-commercial environments. With IP41 ingress protection, the box provides basic defense against solid objects larger than 1 mm and against vertically falling drops of water, making it appropriate for dry indoor locations where minimal moisture exposure is expected.

Advantages

The junction box is designed for straightforward installation and secure containment of cable connections. Its compact dimensions save space while allowing enough room for common low-voltage splices and terminal blocks. The IP41 rating ensures basic safety against dust ingress and dripping water, and the surface-mounted form factor removes the need for recessed mounting or additional wall cutting. The material and finish are selected to provide electrical insulation and mechanical protection suitable for typical household and light commercial wiring tasks.

Suitable for

• Cable splices and junction points for lighting and power circuits indoors
• Mounting small terminal blocks and connectors in distribution runs
• Surface-mounted installations on walls and ceilings in homes, offices and shops
• Organizing short runs of control, alarm or communication cabling in dry environments

Key specifications

• External dimensions: 60 × 60 mm (square footprint)
• Mounting type: surface-mounted enclosure
• Ingress protection: IP41 — protection against solid objects >1 mm and vertical water drops
• Intended use: indoor electrical connection protection and termination housing
• Suitable for: low-voltage wiring, terminal blocks and small cable splices

How to use

Mount the junction box on a clean, flat surface using appropriate screws or anchors for the substrate. Route the cables through the box entry points, strip insulation as required and make connections using suitable connectors or terminal blocks rated for the conductor size. Arrange conductors neatly to avoid mechanical stress on connections, then close the enclosure securely to maintain the IP41 protection. Ensure all connections comply with local electrical codes and, where applicable, switch off the power supply before working on circuits.

Usage recommendations

Use this surface-mounted junction box only in dry indoor locations where IP41 protection is sufficient. Do not expose the enclosure to direct water jets, heavy dust or outdoor conditions. For higher moisture or dust exposure, choose an enclosure with a higher IP rating. Always verify conductor sizes and connector ratings before assembly and follow local wiring regulations or consult a qualified electrician when in doubt.