Epson replacement frame assembly 1736282 for printers — FRAME LD ASSY

Epson replacement frame assembly 1736282 (FRAME LD ASSY) is an OEM service component designed to restore mechanical alignment and structural support inside compatible Epson printers. The part fits into the printer chassis to replace a worn or damaged frame section, helping to reestablish correct positioning of moving parts and maintain stable operation during printing and media handling.

Advantages

This OEM frame assembly offers factory-compatible dimensions and mounting points to ensure accurate fit and reliable interaction with adjacent components. Using an original Epson assembly helps preserve the printer's intended tolerances, reduces the risk of further mechanical wear caused by misalignment, and supports longer service intervals. The replacement frame is intended to simplify repair tasks by providing a ready-to-install unit that restores structural integrity without the need for custom fabrication.

Suitable for

• Service and repair of compatible Epson desktop and production printers
• Restoring mechanical alignment after impact or extended use
• Preventive maintenance to reduce paper jams and mechanical wear
• Parts replacement during refurbishment or redeployment

Key specifications

• Type: replacement frame assembly for internal printer chassis
• Compatibility: OEM part intended for use in specified Epson printer models (refer to service documentation)
• Material: metal and/or molded engineering plastics suitable for printer internals
• Function: restores mounting points, alignment surfaces and structural support for internal mechanisms
• Finish: factory-applied coatings or treatments for dimensional stability and wear resistance

How to use

Install the frame assembly following the printer service manual and safety procedures. Power off the printer and disconnect from mains before beginning repair. Remove covers and any obstructing modules to access the damaged frame area, then detach electrical connectors, fasteners and components mounted to the old frame. Fit the replacement frame, ensuring alignment of mounting holes and engagement points, and secure fasteners to the specified torque values. Reconnect any removed components and perform a mechanical check and test prints to verify correct operation.

Usage recommendations

Use only approved tools and reference the official Epson service documentation for model-specific removal and installation steps. After replacement, run alignment and calibration procedures if available, and observe the printer through an initial test cycle to confirm there are no mechanical interferences or unusual noises.