EUROLITE DMX cable SEC-1 IP65 3-pin 3 m black waterproof

EUROLITE DMX cable SEC-1 IP65 3-pin 3 m black waterproof is a purpose-built DMX connection cable for lighting and stage equipment. The 3-pin configuration provides a standard signal path for DMX512 systems while the 3 m length balances reach and cable management. With an IP65 rating and waterproof connectors, this cable is designed to maintain reliable signal transmission in outdoor, damp or dusty conditions where protection from splashes and low-pressure water jets is required.

Advantages

The cable combines a common 3-pin DMX wiring scheme with rugged IP65-rated construction to resist dust ingress and water exposure. Its molded connectors and sealed connections reduce the risk of corrosion and intermittent contacts that can disturb DMX communication. The 3 m length offers flexibility for linking controllers, dimmers and fixtures without excessive slack, and the black outer jacket provides a neutral appearance on stage or in venue installations.

Suitable for

• Connecting DMX512 controllers to lighting fixtures, dimmers and moving heads
• Outdoor events, festivals and temporary installations exposed to moisture or dust
• Permanent or semi-permanent installations in damp environments such as covered terraces and wet-stage areas
• Touring rigs where weather-resistant cabling is required for quick setup and teardown

When it may not be suitable

This 3-pin DMX cable is intended for standard DMX512 applications; it may not be suitable for systems that require 5-pin DMX connectors or proprietary pinouts. For installations that demand longer cable runs, alternative lengths or signal boosters may be necessary to avoid signal degradation. The IP65 rating protects against dust and low-pressure water jets but is not intended for continuous immersion.

Key specifications

• Connector type: 3-pin DMX (waterproof, sealed)
• Cable length: 3 m
• Protection rating: IP65 (dust-tight and protected against water jets)
• Cable color: black
• Intended signal: DMX512 lighting control

How to use

Ensure power to all lighting equipment is turned off before connecting or disconnecting DMX cables. Align the 3-pin connectors and push to engage, then secure any locking mechanism if present to maintain the waterproof seal. Route the cable to avoid sharp bends, crushing, or high-traffic pinch points and secure runs with appropriate clamps or ties. When setting up outdoor or damp environments, position connectors off the ground where possible and inspect seals before use. After use, wipe connectors dry and store the cable coiled without tight kinks.

What to consider before purchase

• Verify your lighting equipment uses a 3-pin DMX connector rather than 5-pin or proprietary types
• Consider required cable lengths for your setup and whether additional lengths or repeaters are needed
• Confirm that IP65 protection level meets your exposure conditions (not for continuous immersion)
• Assess whether you need reinforced or heavier-gauge cable for high-traffic or permanent outdoor installations

Usage recommendations

Use the EUROLITE DMX cable SEC-1 IP65 for short- to medium-length runs where weather resistance is important. Regularly inspect connector seals for wear, avoid running the cable across areas where it may be crushed, and store dry between uses to prolong service life.