DMX cable EUROLITE SEC-1 IP65 3-pin, 10 m, black — outdoor-rated

EUROLITE SEC-1 IP65 3-pin DMX cable, 10 m in black, is an outdoor-rated signal cable engineered for DMX512 lighting control systems. The cable combines a standard 3-pin DMX connector configuration with an IP65-rated jacket and connector sealing to resist dust and water spray, making it suitable for temporary events and semi-permanent outdoor installations where a reliable DMX signal path is required between controllers, fixtures and moving lights.

Advantages

The cable provides weather-resistant protection through IP65-rated connectors and outer sheathing, reducing the risk of signal loss from moisture or ingress of dust. At 10 m length it balances reach and signal integrity for common stage and event layouts. Using a familiar 3-pin DMX wiring scheme ensures compatibility with a wide range of DMX512 equipment, and the black finish helps the cable remain discreet in stage and outdoor environments.

Suitable for

• Temporary outdoor events and concerts where DMX-controlled fixtures are exposed to spray or dust
• Semi-permanent outdoor lighting installations such as façades, architectural lighting and terraces
• Connecting DMX controllers to moving lights, dimmers and LED fixtures in open-air venues
• Backstage, outdoor stages and tented setups requiring weather-resistant signal cabling

When it may not be suitable

The SEC-1 IP65 cable is designed for signal transmission and environmental resistance but is not intended as a power cable; it should not be used to carry mains power. For fully submerged applications or locations that require higher protection than IP65 (for example continuous immersion), a cable and connector system rated for that environment should be chosen. For long permanent runs over distances greater than the recommended DMX segment length, line boosters or DMX over Ethernet solutions may be more appropriate.

Key specifications

• Cable type: 3-pin DMX signal cable
• Length: 10 m
• Connector configuration: 3-pin (male/female as required by DMX setups)
• Ingress protection: IP65-rated for dust and water spray resistance
• Color: Black
• Application: DMX512 lighting control signal transmission for outdoor use

How to use

Connect the cable between DMX controller output and the input of the first fixture or between fixtures following the standard DMX512 daisy-chain topology. Ensure connectors are fully mated and any threaded or sealing rings are tightened to maintain the IP65 protection. Avoid sharp bends and fastening that could compress the jacket; secure the cable with appropriate outdoor-rated clamps or ties. For runs longer than a single DMX universe or when terminating the line, follow DMX512 best practices such as using a termination resistor at the far end.

What to consider before purchase

• Confirm that 3-pin DMX connectors match your fixtures and controller (some equipment uses 5-pin DMX)
• Evaluate whether IP65 protection meets the environmental conditions at your site (spray vs. immersion)
• Check required run length and whether 10 m sections fit your layout or if multiple cables and signal management are needed

Usage recommendations

For reliable outdoor DMX performance, route cables to avoid standing water, use proper sealing at connection points, and inspect connectors for wear before each event. Where multiple lengths are joined, use IP65-rated couplers and consider line termination and signal boosters for long chains to preserve DMX signal integrity.